User manual KENWOOD KDC-2027SG ANNEXE 503

[. . . ] Also avoid places with too much dust or the possibility of water splashing. Do not set the removed faceplate or the faceplate case in areas exposed to direct sunlight, excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. To prevent deterioration, do not touch the terminals of the unit or faceplate with your fingers. [. . . ] Enter Audio Control mode Press the [AUD] button for at least 1 second. Each time the button is pressed the items that can be adjusted switch as shown below. Adjustment Item Display Bass level "BAS" Middle level "MID" Treble level "TRE" Balance "BL" Fader "FD" Exit Audio Control mode Press the [AUD] button. You can recall the best sound setting preset for different types of the music. Each setting value is changed with the <Speaker setting> (page 8). When the System Q setting is changed, the Bass, Middle, and Treble set in audio control replace the System Q values. Enter clock adjustment mode Press the [ADJ] button for at least 2 seconds. A red indicator will blink on the unit after the faceplate is removed, warning potential thieves. set the DSI While pressing the [1] and [3] button , press the [SRC] button. The faceplate of the unit can be detached and taken with you, helping to deter theft. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. Each time the button is pressed for at least 1 second the Monaural Reception turns ON or OFF. Select the frequency to put in the memory Press the [4] or [¢] button. Put the frequency in the memory Press the [1] -- [6] button for at least 2 seconds. On each band, 1 station can be put in the memory on each [1] -- [6] button. Each time the [FM] button is pressed it switches between the FM1, FM2, and FM3 bands. When 6 stations that can be received are put in the memory Auto Memory Entry closes. Playing the first part of each song on the disc you are listening to and searching for the song you want to listen to. Release it when the song you want to listen to is played Press the [SCAN] button. [. . . ] to link the unit's power to the ignition , connect the ignition cable (ACC. Red) to a power source that can be turned on and off with the ignition key. Engage the catch pins on the removal tool and remove the two locks on the lower level. Insert the two removal tools deeply into the slots on each side, as shown. [. . . ]