User manual KENWOOD KNA-DV3200 INSTALLATION MANUAL

[. . . ] â· When extending the ignition, battery or ground cables, make sure to use automotive-grade cables or other cables with an area of 0. To prevent short circuits, never put or leave any metallic objects (e. If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. [. . . ] â· If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the old fuse with one with the same rating. â· Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent a short circuit, do not remove the caps from unused terminals or from the ends of the unconnected cables. â· After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. Insulate unconnected cables with vinyl tape or other similar material. â· Thoroughly wipe away oil and other dirt from the installation surface. If the unit does not seem to be working right, try pressing the reset button first. Immediately after installation, the information of the GPS satellite is taken in and it may take several minutes to measure the position of the current location. After measuring the position of the current location, drive of about 6. 8 mile/h (40 km/h) in a place where there are few obstacles (for example, buildings and tree-lined streets). Until the initial values are set, the position and speed indication of you car's mark on the navigation system may differ greatly from the actual values. â· The proper connection of the car speed signal cable can be checked with the menu screen. Check that there are no wiring cables or other parts beneath the floor mat before cutting the floor mat. Select for installation a location where the unit can be placed completely horizontal. [. . . ] After wiping off the dirt or oil from the attachment location, attach the Remote Control Sensor. Wipe off the dirt or oil from the surface to which the Sensor is attached. â· Avoid locations under direct sunlight or near the TV monitor where signals from the remote controller are not received easily. [. . . ]