User manual KENWOOD KRF-V6070D

[. . . ] Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. [. . . ] The bass and treble levels are adjustable from -10 to +10 in 2 step increments. 1 Press the SPEAKERS ON/OFF key so that the speaker indicator goes off. You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo modes. Press the key once to select the maximum (+10) low frequency emphasis setting. This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. If you turn off all of the speakers when in surround mode, the surround mode will be canceled as well, resulting in stereo playback. 3 Press and hold the DIMMER key for more than 2 seconds to select the A-REC or M-REC mode during digital input. 2 A-REC mode : The digital input signals (DTS, Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are ready for recording. 3 M-REC mode : The input signal type at the moment this mode is selected is held throughout this mode. 1 Use the INPUT SELECTOR knob to select the source (other than "MD/TAPE") you want to record. 1 Use the INPUT SELECTOR knob to select the video source (other than "VIDEO1") you want to record. Usually use the A-REC (Auto-Record) mode to record audio input sources. When the digital mode changes during recording in the A-REC mode, the audio input source may be interrupted momentarily. If the audio reproduction stops in the middle due to change in the input signals, etc. The receiver can store up to 40 stations in the memory and recall them by one-touch operation. Radio stations can be classified into RDS (Radio Data System) stations and other stations. Tuners and receivers designed for RDS reception can extract the information from the broadcast signal for use with various functions, such as automatic display of the station name. If fewer than 40 RDS stations have been stored in the preset memory, regular FM stations will be stored in the remaining places. Radio Text function Displays the radio text data transmitted by some RDS stations when you press the RDS Disp. The "RDS" indicator lights up when an RDS broadcast (signal) is received. Before using a function utilizing the RDS, be sure to perform the RDS Auto Memory operation by referring to the description in "Presetting RDS stations (RDS AUTO MEMORY)". Each press switches the tuning method as follows: 1 AUTO lit (auto tuning) "AUTO" indicator lights 2 AUTO not lit (manual tuning) up in the display. [. . . ] Please note that resetting the microcomputer will clear the contents of the memory and return the unit to the state it was in when it left the factory The standby indicator blinks and sound is not output. Turn the power off, eliminate the shortcircuiting, then turn on the power again. Sound is not output from the surround speakers and / or the center speaker, or their sound is very soft. The surround and/or center volume controls are set to the minimum level. [. . . ]