User manual KINZO 25C19

[. . . ] A) Your hammer drill has been designed for drilling in concrete, stone, wood and steel and for light chipping and chiseling applications. WARNING Read this manual carefully before using the machine, for your own safety. [. . . ] Before inserting or removing a drill, always pull the plug from the wall socket. A) The machine must be set to the required function (drilling, hammer drilling or chiseling) before use. I For drilling without hammering (in soft stone, wood or steel) you turn the hammer function switch (2) to position and the chisel function switch (3) to position . Only set the hammer functions (2) and (3) when the machine is switched off. I Slide the dust collector (10) onto the shaft of the bit and mount the bit as described above in the drill chuck. Instructions for use I Before inserting a drill bit or chisel, always grease the shaft. I When a cold machine is to be used for chiselling, first let it run idle for a few minutes to allow the grease to spread in the mechanism. I If the machine does not hammer properly, first check if the switch is in the hammering position and if the drill bit or chisel is correctly fitted. I Vibrations may cause slight leakage of oil through the joints of the housing. I After mounting new carbon brushes, let the machine run at no load for 15 minutes. Level of sound pressure measured according to EN 50144: 25C19 Weighted root mean square acceleration value according to EN 50144: 25C19 A) After approximately 50 hours the machine must be lubricated. CLEANING AND MAINTENANCE The machine does not require any special maintenance. [. . . ] För mejsling vrider du slagfunktionens och omkopplare (2) till läget mejslingsfunktionens omkopplare (3) till läget . I För borrning utan slagfunktion (i mjuk sten, trä eller stål) vrider du slagfunktionens omkopplare (2) till läget och mejslingsfunktionens omkopplare (3) till läget . [. . . ]