User manual LA CROSSE TECHNOLOGY WS-2010

[. . . ] You may press the "Unit" key to switch between inches and millimeters for rain measurement. "Wind" for hour, "Rain" for minute, "Alarm" for month, "Sensor" for day. Three "7's" are displayed; in indoor temperature, wind, and rainfall. This is the addressing for those sensors, and must be set to 7's. [. . . ] Press the "Min/Max" key to toggle between minimum alarm and maximum alarm. When a minimum alarm is set, any value received below that will sound the alarm; press the "Alarm" key to shut off the alarm. Rainfall can be viewed as total (cumulative until reset), 1h (1 hour total updated at the bottom of the hour), or 24h (24 hour total from 7 am to 7 am). For example, at 3:45 pm on Wednesday, you will see the total rainfall since the last reset, the 1 hour total from 2:30 pm to 3:30 pm. , and the total from 7 am Tuesday to 7 am Wednesday. Wind readings are continuously monitored, and transmitted once every three minutes. The value displayed is the maximum wind recorded during that three minute period, along with the average wind direction, represented by arrows around the compass. These sensors also include a Lithium button cell battery that will recharge during the day and power the unit at night. Occasionally the display/receiver can lose transmission from a sensor and display "--. -". This may be due to outside interference (cordless phones, wireless headphones, etc. ) or not enough sunlight. Such losses of signals should be very infrequent, and will return automatically through an automatic search at 8 am and 6 pm. If the loss of communication is consistent, it may require moving the sensor. The forecast and weather trend is based on the changing air pressure over time. The symbols are relative to current weather; thus, a sunny icon may not indicate the forecast of sunny weather, but rather clearing conditions. The forecast is for 6 to 12 hours in the future, and is about 75% accurate overall. Areas that are not affected as much by the air pressure change may find the forecast accuracy to be less than 75%. 1 Optional accessories are available for your unit WS-2010, WS-2210, or WS-7015. These are available through your retailer or by contacting La Crosse Technology directly. A total of nine temperature and humidity may be received; two are included. The indoor sensor included will always be displayed on the left side of the display. All other temperature and humidity sensors will be displayed on the right side, along with a number. "Addressing" an additional sensor will be necessary for it to be viewed as the desired number. The sensors that are included and most additional sensors are addressed from the factory and do not need addressing. WS2010-20 indoor temperature, humidity, and pressure sensor is included, and no more may be added. [. . . ] This warranty does not cover any defects resulting from improper use, use other than home or office (i. e. on a boat) unauthorized repairs, faulty batteries, or the Weather Stations inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS WEATHER STATION. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. [. . . ]