User manual LA CROSSE TECHNOLOGY WS-7016U

[. . . ] Check the LCD screen of the Remote Control Sender to see if there is a temperature reading. If there is no reading check the polarity of the batteries or replace with new batteries. Observing that the rubber weather-seal is in place; replace battery cover, screw, and mounting bracket. B. INDOOR TEMPERATURE STATION Note: After the batteries are installed, DO NOT press any buttons. [. . . ] To reset both the minimum and maximum temperatures--press and continue to hold the INDOOR button, while you press and hold the RESET button. 14 2. To return to the current indoor temperature, press and hold the INDOOR button two times, holding for 1 second each. 1. To reset both the minimum and maximum temperatures--press and continue to hold the OUTDOOR button, while you press and hold the RESET button. To return to the current outdoor temperature, press and hold the OUTDOOR button two times, holding for 1 second each. The absence of an arrow indicates that the temperature is stable. VII. THE REMOTE CONTROL SENDER Note: To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Control Sender. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location before permanently mounting the Remote Control Sender. There should be a change of temperature in the OUTDOOR LCD within 6 minutes. 16 The Remote Control Sender can be mounted in two ways: with the use of screws or, using the adhesive tape. MOUNTING WITH THE SCREWS a) Remove the mounting bracket from the Remote Control Sender (figure 2). Through the three screw holes of the bracket, mark the mounting surface with a pencil. c) Where marked, drill holes into mounting surface using an appropriate size drill bit. 17 2. MOUNTING WITH ADHESIVE TAPE a) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Adhere the tape to the designated area on the back of the mounting bracket. Position the Remote Control Sender in the desired location, ensuring that the Indoor Temperature Station can receive the signal. 18 B. THE INDOOR TEMPERATURE STATION Note: Before mounting the Indoor Temperature Station make sure that it is able to receive signals from the Remote Control Sender. The Indoor Temperature Station can also be mounted in two ways: with the table stand or, on the wall with the use of a wall hanging screw (not included). USING THE TABLE-STAND a) The Indoor Temperature Station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the Indoor Temperature Station in an appropriate location. 2. WALL MOUNTING Remove the table stand. b) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. c) Place the Indoor Temperature Station onto the screw using 20 a) 19 the hanging hole on the backside. [. . . ] To reset the OUTDOOR MINIMUM AND MAXIMUM TEMPERATURES, follow step 1 above and the directions in sections V. A. This will reset the minimum and maximum for only the selected Remote Control Sender. The Remote Control Sender may be out of its 80 foot (25m) range--bring the units closer together. "--. -" appears in the OUTDOOR LCD of the Indoor Temperature Station. (continued) Obstacles such as walls, concrete, metal window frames, or large metal objects, may be obstructing signal transmission from the Remote Control Sender--Relocate the Remote Control Sender, within range, where there are no obstructions. [. . . ]