User manual LA CROSSE TECHNOLOGY WS-7107U

[. . . ] Fog and mist will not harm your remote temp/humidity sensor but direct rain must be avoided. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window can have up to 30 feet of resistance and an 6 interior wall can have up to 20 feet of resistance. To complete the set up of your indoor weather stations after the 10 minutes have passed, please follow the steps below. [. . . ] These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, the TX3UP will monitor the temperature via a probe for use in pools, spas, etc and the TX4U or TX7U will monitor temperature and humidity. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temp/humidity sensor units, and in numeric sequence. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. 14 1. It is necessary to remove the batteries from all units currently in operation. 2. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide) into the remote sensors. Follow the Detailed Set-Up Guide for programming and operating instructions. 15 D. To view the temperature of a different remote sensor unit, press and release the "CH" button. A shift from one "boxed" number to the next should be observed in the OUTDOOR LCD. 2. To view the Minimum/Maximum temperature: first select from which remote temp/humidity sensor to read data from (indicated by the "boxed" number). Pressing and releasing the "MIN/MAX" button will toggle through the minimum and maximum indoor temperature, and the minimum and maximum outdoor temperature. 16 3. To reset the Minimum/Maximum readings, press and hold the "MIN/MAX" button for five seconds. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temp/humidity sensor on an outside Northfacing wall. The sending range is 330ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location temporarily to test reception capability before permanently mounting. A. Reattach the remote temp/humidity sensor to the mounting bracket. B. The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand, all that is required is to place the indoor weather station in your desired location. To wall mount: a) Remove the table stand by pulling down on the stand from the rear and rotating forward. c) Place the indoor weather station onto the screw using the hanging hole on the backside. d) Gently pull the indoor weather station down to lock the indoor weather station into place. 18 TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature or humidity is displayed. [. . . ] Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com 27 (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. [. . . ]