User manual LA CROSSE TECHNOLOGY WS-7208TWC

[. . . ] To complete the set up of your indoor temperature station after the 10 minutes have passed please follow the steps in the detailed set up guide on page 8-9. INVENTORY OF CONTENTS 1. Instruction Manual and Warranty Card. 5 Figure 1 Figure 2 Holder ADDITIONAL EQUIPMENT (not included) 1. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation 6 1. 2. Install 2 AA batteries in the remote temperature sensor. Do not press any buttons for at least ten minutes. Setting the time 1. [. . . ] In areas where the weather is not affected by the change of air pressure, this feature will be less accurate. Weather Icons There are 3 possible weather icons that will be displayed in the FORECAST LCD: 11 Sunny--indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds-- indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with Rain-- indicates that the weather is expected to get worse (not that the weather will be rainy). The weather icons change when the unit detects a change in air pressure. The icons change in order, from "sunny" to "partly sunny" to "cloudy" or the reverse. It will not change from "sunny" directly to "rainy", although it is possible for the change to 12 occur quickly. If the symbols do not change then the weather has not changed, or the change has been slow and gradual. Weather Tendency Arrows Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (on the left side of the LCD) and one that points down (on the right side of the LCD). An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain good. An arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a North-facing wall. 13 The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. Remote Temperature Sensor Remove the mounting bracket from the remote temperature sensor. Mount the bracket in the desired location with either screws or adhesive tape. Indoor Weather Station The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor weather station in an appropriate location. To wall mount the indoor weather station first remove the table stand. Next insert an appropriate screw in your desired location. 14 Using the integrated hanging hole on the back of the unit, slip indoor weather station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. Remove all batteries, reinsert into remote temperature sensor first, then into the indoor weather station. Place remote temperature sensor and indoor weather station in position so the 15 straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. [. . . ] The indoor weather station will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty 19 batteries, or the indoor weather stations inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS INDOOR WEATHER STATION. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. [. . . ]