User manual LA CROSSE TECHNOLOGY WS-9029U-IT

[. . . ] If the Wireless Weather Station does not display both temperatures after the 15 minutes, please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 15 minutes you can place your temperature sensor outdoors, and set your time. The temperature sensor should be placed in a dry, shaded area (ex: under the eve of a roof). Any walls that the signal will have to pass through will reduce distance. [. . . ] The indoor and outdoor temperatures displayed when "MAX" appears are the maximum recorded values. The maximum records will display for 30 seconds before returning to the normal display mode. While "MAX" is still displayed press the min/max/+ button again to return to the current data display. Or you can wait 30 seconds, during either the minimum or the maximum readings, and the unit will automatically return to current data readings. RESETTING THE MIMIMUM AND MAXIMUM RECORDS All the minimum and maximum records (minimum and maximum) will be reset after the min/max/+ button is pressed and held for 5 seconds. OPTIONAL CHANNEL 2 TEMPERATURE PROBE When the temperature probe is connected to the remote temperature sensor, the WS-9029U's channel 1 will display the remote temperature sensor data, and channel 2 will display the temperature probe data. The remote temperature sensor data will always be displayed on the channel 1 and the temperature probe on the channel 2. If the probe on remote temperature sensor is unplugged, the "probe channel" on WS-9029U LCD will show "---", the remote temperature sensor displayed value will still be shown. The Weather Station will automatically detect the temperature probe and will display the temperature probe data in channel 2. ADDING TEMPERATURE SENSORS (OPTIONAL) The WS-9029U is able to receive signals from 2 remote temperature sensors (TX-25U). These extra sensors can be purchased through the same dealer as this unit A. Remove all the batteries from the receiver and sensor(s) and wait 60 seconds. During these 60 seconds, press any button 20 times to discharge any excess power. Within 2 minutes of powering up the first sensor (Temperature sensor with probe), insert the batteries to the Weather Station. Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature/humidity and the time as 12:00 will be displayed, and the signal reception icon will flash. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. The outdoor temperature from the first sensor (channel 1) should then be displayed on the Weather station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. If the temperature probe has been used, the outdoor temperature from channel 2 will then be displayed. Note: The temperature probe from the first sensor will always occupy "channel 2". If you choose not to use the temperature probe, Channel 2 will display "---". [. . . ] This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]