User manual LA CROSSE TECHNOLOGY WS-9160U-IT

[. . . ] If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. In order to ensure sufficient 915 MHz transmission, the final position between the Temperature Station and the transmitter should not be more than 330 feet / 100 meters (see notes on "Positioning" and "915 MHz Reception"). Please be sure you are using name brand plain alkaline batteries dated at least 7 years in advance or testing to 1. 48 on a voltmeter that reads in numbers. The Outdoor Temperature Transmitter · Remote transmission of outdoor temperature to Temperature Station by 915 MHz · Rain resistant casing · Wall mounting case (Mounting at a sheltered place. User shall remove all the batteries from the Temperature Station and transmitters and wait 60 seconds if setting has been done with one transmitter first. [. . . ] On the other hand, the short blinking of the icon shows that a reception is being done now. For better distinctness the LCD screen is split into 3 sections displaying the information for time, indoor temperature, and outdoor temperature. Section 1 - TIME · Display of time. Indoor Temperature in °F/°C Outdoor Temperature in °F/°C Sensor identification No. (shown when more than one sensor is used) Receiver Low battery indicator Section 2 - INDOOR TEMPERATURE · Display of indoor temperature Section 3 - OUTDOOR TEMPERATURE · Display of the outdoor temperature Outdoor Reception Signal icon* Transmitter Low battery indicator 13 14 MANUAL SETTING: 12/24- HOUR TIME DISPLAY SETTING AND TEMPERATURE UNIT (°C/°F) SETTING To display the time in 12-hour or 24-hour mode (default setting: 12h): MANUAL TIME SETTING Set the time of Temperature Station by the following steps: Minutes (flashing) Flashing Hours (flashing) 1. In normal display mode, press and hold the SET key for about 3 seconds. Press the + key to adjust the hour (Press and hold to allow fast advancing). Press the + key to adjust the minute (Press and hold to allow fast advancing). Press SET key once more to return to normal display. Note: When the time display is set as 12-hour mode, the temperature unit will be fixed to °F; when the time mode is in 24-hour, the temperature unit will be fixed to °C. 15 VIEWING THE MINIMUM AND MAXIMUM RECORDS: To view the MIN/MAX indoor and outdoor temperature records: 1. Press the MIN/MAX key once to view the minimum indoor and outdoor temperature. 3. Press the MIN/MAX key once more to view the maximum indoor and outdoor temperature. Press the MIN/MAX key to return to current temperature display. Note: The transmitter number will only be displayed if more than one transmitter is used. RESETTING THE MINIMUM AND MAXIMUM RECORDS: To reset the MIN/MAX records: 1. Press and hold the MIN/MAX key again for about 3 seconds to reset all the minimum/ maximum data to the current temperature values. Note: All indoor and outdoor MIN/MAX records from all transmitters will be reset at the same time. TEMPERATURE TRANSMITTER: The outdoor temperature is measured and transmitted to the Temperature Station every 4 seconds approximately. The range of the Temperature Transmitter may be affected by the temperature. Please bear this in mind when placing the transmitter. Minimum icon Maximum icon 1. 2. When several transmitters are used: Select the desired channel first by pressing the CH key. Press the MIN/MAX key to view the selected MIN/MAX records of selected channel. 17 18 915 MHz RECEPTION CHECK The Temperature Station should receive the temperature data within few minutes after set-up. If the temperature data is not being received about 2 minutes after setting up (the display shows "- -" after consecutive failures in receiving signal for times), please check the following points: 1. [. . . ] LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology, Ltd 27 2809 Losey Blvd. [. . . ]