User manual LA CROSSE TECHNOLOGY WT-2171U

[. . . ] The signal can be received up to 2, 000 miles away through the internal antenna in the alarm clock. Due to the nature of the Earth's Ionosphere, reception is very limited during daylight hours. The alarm clock will search for a signal every night when reception is best. The WWVB radio station derives its signal from the NIST Atomic clock in Boulder, Colorado. [. . . ] The time zones are abbreviated with three letters as follows: Eastern Central Mountain Pacific EST CST MST PST You can select whether or not your alarm recognizes the daylight saving time changes twice a year and automatically changes. Some areas do not change time for daylight saving time (Arizona and parts of Indiana). · · · · · Press and release the "AL/HR" button to select the desired time zone. "DST" will be displayed to the left of the time zone abbreviation. Press and release the "MODE/MIN" button to toggle between daylight saving time on and off. Press and release the "Snooze" button twice to return the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Figure Two Display Mode Setting The display below the time can be switched between showing the seconds and the alarm time. To switch between these two modes press and release the "MODE/MIN" button. Setting the Alarm To set the alarm press and hold the "AL/HR" button for 4 seconds. · · · · The alarm time will flash in the bottom left of the LCD screen. Press and release the "AL/HR" button to advance to the desired hour. Press and release the "MODE/MIN" button to advance to the desired minute. Press and release the "Snooze" button twice to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. 4 Operating the Alarm To turn the alarm on press and release the "AL/HR" button. The alarm icon (((·))) will be displayed in the lower right of the LCD to indicate that the alarm has been turned on. By pressing the snooze button the alarm will be suspended for 8 minutes. Manual Time Setting Option You can also manually set the time on your travel alarm by pressing and holding the "MODE/MIN" button (figure two) on the front of your travel alarm for 4 seconds. · · · · · · The time zone abbreviation will appear in the LCD. Press and release the "MODE/MIN" button to advance the minutes. Press and release the "Snooze" button twice to return the normal display mode or wait 20 seconds and the travel alarm will automatically return to the normal display mode. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The time and date will not set initially. [. . . ] This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the travel alarms' inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS TRAVEL ALARM. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. 6 For warranty work, technical support, or information, contact La Crosse Technology at: La Crosse Technology, Ltd 2809 Losey Blvd. [. . . ]