User manual LA CROSSE TECHNOLOGY WT-2192

[. . . ] The signal can be received up to 2, 000 miles away through the internal antenna in the alarm clock. Due to the nature of the Earth's Ionosphere, reception is very limited during daylight hours. The alarm clock will search for a signal every night when reception is best. The WWVB radio station derives its signal from the NIST Atomic clock in Boulder, Colorado. [. . . ] The time zones are abbreviated with three letters as follows: Eastern Central Mountain Pacific · EST CST MST PST Press and hold the "MODE/MIN" button for 3 seconds. NOTE: The default (factory) time zone setting is Eastern time zone. · · Press and release the "AL/HR" button to select the desired time zone. Press and release the "Snooze" button twice to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Daylight Saving Time Setting You can select whether or not your alarm recognizes the daylight saving time changes twice a year and automatically changes. Some areas do not change time for daylight saving time (Arizona and parts of Indiana). · · · · · Press and hold the "MODE/MIN" button for 3 seconds. "DST" will be displayed to the left of the time zone abbreviation. Press and release the "MODE/MIN" button to toggle between daylight saving time on and off. Press and release the "Snooze" button twice to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Display Mode Setting The display below the time can be switched between showing the seconds and the alarm time. To switch between these two modes press and release the "MODE/MIN" button. Setting the Alarm To set the alarm press and hold the "AL/HR" button for three seconds. · · · · The alarm time will flash in the bottom left of the LCD screen. Press and release the "AL/HR" button to advance to the desired hour. Press and release the "MODE/MIN" button to advance to the desired minute. Press and release the "Snooze" button to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Operating the Alarm and Snooze To turn the alarm on press and release the "AL/HR" button. The alarm icon will be displayed in the lower right of the LCD to indicate that the alarm has been turned on. 4 The alarm will sound for 100 seconds once activated. By pressing the snooze button the alarm will be suspended for 8 minutes. Operation of the snooze function can be done in two ways: · Press and release the "SNOOZE" button on the front of the travel alarm. · With the travel alarm resting open on a flat surface, by gently pushing back on the top of the alarm. NOTE: This movement causes the opened lid to activate a second snooze button which is located on the bottom of the travel alarm (it can be seen just below the battery compartment). TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The time and date will not set initially. [. . . ] Some States do not allow the exclusion of consequential or incidental damages; therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact La Crosse Technology 1116 South Oak Street La Crescent, MN 55947 Phone: 507. 895. 7095 Fax: 507. 895. 8000 e-mail support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) Website www. lacrossetechnology. com THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. [. . . ]