User manual LASKO PH200

[. . . ] Do not place on soft surfaces, like a bed, where openings may become blocked. Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord so the Heater or other objects are not resting on it. Arrange Power Cord away from room traffic and where it will not be tripped over. [. . . ] Arrange Power Cord away from room traffic and where it will not be tripped over. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0. Do not use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. It must NOT be used in potentially dangerous locations such as flammable, explosive, chemicalladen or wet atmospheres. This Heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate a Heater where it may fall into a bathtub or other water container. For ease of assembly, lay the Heater down so that the front grill and control panel are facing up. Thread the Power Supply Cord through the large hole in the Base Assembly. NOTE: The Cord Channel on the bottom of the Base should be towards the back of the Heater. Thread the Power Supply Cord through the center of the Column Support Assembly. Pressing the ( ) or ( ) Button will prompt the Heater into High heat and will allow the thermostat to be set at a desired temperature. When the air temperature reaches 3 degrees above the SET temperature, the heater will shut off. When the air temperature drops 1 degree below the SET temperature, the unit will turn on. All the functions performed with the Remote Control work identically to the manual controls, except that you are unable to change from °F to °C with the remote control. If you lose your remote control, please call Customer Service to order a replacement at 1-800-233-0268, Monday through Friday, between the hours of 8:00 a. When an overheat temperature is reached, the Heater will automatically shut off. After the 10 minutes, plug the Heater in again and follow the Operation Instructions described in this instruction manual. If your heater shuts off unexpectedly or fails to operate, the above-mentioned safety feature may have been activated to prevent overheating. The Heater may be off because it has reached the desired temperature setting. If you have a problem that can not be resolved by the steps listed above, contact Technical Assistance at 1-800-233-0268, Monday through Friday, between the hours of 8am and 5pm EST. [. . . ] The Heater may be off because it has reached the desired temperature setting. If you have a problem that can not be resolved by the steps listed above, contact Technical Assistance at 1-800-233-0268, Monday through Friday, between the hours of 8am and 5pm EST. Clean the Heater grill with the vacuum brush attachment of your vacuum cleaner. SERVICING: All other servicing, with the exception of general user-maintenance, should be performed by an authorized service representative. [. . . ]