User manual LIFT-MASTER 92LM

[. . . ] Model 92LM Security& 2-Channel Remote Control OWNER'S MANUAL NOTICE: To comply with FCC rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. WARNING Children operating or playing with a garage door opener can injure themselves or others. [. . . ] Its code can be matched to other CGI manufactured fixed code or billion code remotes. The code between this channel and the receiver remains constant until reprogrammed. WHEN USED WITH SECURITY& GARAGE DOOR OPENERS To program the opener to accept the remote control code: 1. Press and release the "Smart" (learn) button on the opener panel. The indicator light on the panel will begin to blink and the opener lights will flash once. Adding a remote can also be done from the door control, as follows: 1. TO ERASE ALL REMOTE CONTROL CODES FROM THE RECEIVER Press and hold the "Smart" button on the opener panel until the indicator light turns off (about 6 seconds). Then follow the steps above to re-program each remote control. CAUTION Model 92LM SECURITY& Remote Control Yellow battery indicator light Smooth push button Grooved push button SECURITY& Garage Door Opener 1 2 3 9 7 5 3 1 9 7 5 3 1 KG KG "Smart" (learn) Indicator light button Figure 1 Figure 2 WHEN SEVERAL REMOTES OPERATE ONE DEVICE To match the 92LM to another CGI manufactured remote's code (Remote Control X): 1. Press and hold both push buttons of the 92LM until the battery indicator light begins to blink. (It will blink for 30 seconds; during this time it is in "learn" mode. ) 2. [. . . ] This code will remain inside the remote control until replaced with a new code by repeating the above steps. AVERTISSEMENT Replacement Parts Model 92LM Security& remote case, cover, screw (circuit board not included) . . 29C128 FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 114A2170 © 1997, Chamberlain Group Inc. [. . . ]