User manual NAD NAD-S100

[. . . ] Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. The unit should be installed so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through its ventilation openings. [. . . ] Switch the unit and all ancillary equipment off before making any connections. Red and white are Right and Left audio respectively, and yellow for NAD-Link. Where additional leads are required, use high quality leads and connectors for optimum performance and reliability. Ensure that leads and connectors are not damaged in any way and all connectors are firmly pushed home. If the unit is not going to be used for some time, disconnect the plug from the AC socket. Should water get into your S100, shut off the power to the unit and remove the plug from the AC socket. Have the unit inspected by a qualified service technician before attempting to use it again. Apart from the twin RCA lead, most turntables also include a single wire earth lead. Before connecting the cable to a live wall socket ensure that it is firmly connected to the NAD S100's AC Mains input socket first. Always disconnect the AC Mains cable plug from the live wall socket first, before disconnecting the cable from the S100 Mains input socket. voltage conversion: A notice printed on the rear indicates the AC power-line voltage that the preamplifier requires. However, every model S100 amplifier has a "universal" power supply that can be modified easily for operation in other countries. If you wish to transport your S100 to a nation that employs a different power-line voltage, an authorised NAD dealer or service agency can convert it for such use. Use a twin RCA-to-RCA lead to connect the CD player left and right `Audio Outputs' to these inputs. Input for the audio signal from a stereo VCR (or stereo TV/Satellite/Cable receiver) or other line-level audio source. Using twin RCA-to-RCA leads, connect to the left and right `Audio Outputs' of the unit to these inputs. Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to these inputs. [. . . ] Also you can use TAPE 1 as the source and copy to TAPE 2 but TAPE 1 MONITOR Input has to be selected for the duration of the recording. Pressing the POWER button turns the unit On and after a few seconds, the Power indicator LED will extinguish. When the S100 is switched On, pressing the Standby button on the remote handset will put the S100 into Standby mode and the Power indicator will light up blue. [. . . ]