User manual NIKON EH-6A

[. . . ] Before using the product, thoroughly read both this document and the camera manual. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. [. . . ] This symbol indicates that this product is to be collected separately. The following apply only to users in European countries: · For more information, contact the retailer or the local authorities in charge of waste management. The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. The accessory power cord must be used For USA only: Over AC 125 V Use a power cord suited to the voltage in use with AC 250 V 15 A rated plugs (NEMA 6P-15) and a minimum of SVT type cord for insulation and for anything over AWG 18 in size. To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it can be seen by all those who use the product. Do not apply excessive force to the DC plug or cable while the AC adapter and camera are connected. ⷠDo not use with travel converters or adapters designed to convert from one voltage to another or with DC-to-AC inverters. Failure to observe this precaution could damage the product or cause overheating or fire. Follow these steps to connect the adapter (Figure 2; illustration shows D3): Plug the AC adapter plug into the AC adapter (Figure 2-a). 1 Open 2 (Figurethe camera DC-IN connector cover and insert the DC plug into the DC-IN connector 2-b). When operating the camera with the AC adapter, take care that the camera does not accidentally become unplugged. [. . . ] When both the EH-6a and the UC-E4 USB cable are connected, these clips can be used to clip the two cables together, preventing the cables from tangling. Improvements to this product may result in unannounced changes to specifications and external appearance. [. . . ]