User manual NIKON LASER 500G BROCHURE

[. . . ] Reproduction of copyright works such as books, music, pictures, woodcut printings, maps, drawings, movies and photographs is prohibited except for personal, family or similar limited usage. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Note: Please use the SCSI cable listed on Page 2 Accessories supplied with the scanner. Using other signal cables may exceed the limits of the class B Part 15 of FCC Rules. This manual describes the steps from unpacking to setting up the transparency unit and connecting it to your scanner. Please read this manual thoroughly to ensure proper operation of the unit. Insert screws into the center of each hinge bracket and tighten them down. Plug the 25-pin connector cable into the OPTION port on the rear of your scanner. Raise the transparency unit and place a transparency on the scanner's document setting glass. Make sure that the transparency is placed within the area bordered by the green rulers. The scanner is ready to scan transparencies after launching your scanning software. Be sure to select the transparency scan type from your software to scan transparencies. Note: Before you use the transparency unit and the scanner, you need to install the application software and scanner software/ driver. [. . . ] Note: Before you use the transparency unit and the scanner, you need to install the application software and scanner software/ driver. The holder's frame provides ample area for grasping the transparency without risking damage from fingerprints and surface scratches. Regularly cleaning the glass platten of the transparency unit will ensure that dirt or smudges will not reduce the quality of your scanned images. [. . . ]