User manual ORION TELESCOPES & BINOCULARS 09238

[. . . ] 1/4"-20 Adapter for SkyView Equatorial Mount #9238 Parts List 1 1/4"-20 adapter plate assembly 2 1/4" flat washers 2 1 Allen-head screws Allen wrench hold the top and bottom plates together. [. . . ] Now insert the stud up through the hole in the top plate, as shown in the diagram, and reattach the two plates. (Note that the washer(s) should be under the top plate, not on the cork side. ) Reattach your instrument to the adapter and make sure the threaded stud no longer bottoms out. To Telescope Cork Pad Installation Remove the telescope tube rings from your SkyView equatorial mount. Place the 1/4"-20 adapter plate assembly on the equatorial head, with the cork surface facing up. Secure it in place with the two Allen-head screws, using the supplied Allen wrench. There is some variation in the depth of 1/4"-20 receptacles in different instruments. You may discover that the 1/4"-20 stud "bottoms out" in the hole before the instrument is snug against the cork pad. [. . . ] If this occurs, remove the adapter assembly from the equatorial head and unscrew the two hex-head bolts that Bottom Plate Top Plate 1/4"-20 Stud Allen Head Screw (2) Hex Head Bolts (2) To SkyView Equatorial Head 1/4"-20 Adapter for SkyView Equatorial Mount Customer Support (800) 676-1343 Email: support@telescope. com Providing Exceptional Consumer Optical Products Since 1975 Corporate Offices (831) 763-7000 P. O. [. . . ]