User manual PANASONIC ER-GP80

[. . . ] 5  English WARNING WARNING Do not immerse appliance in water or wash it with water. Immediately stop using and remove the adaptor if there is an abnormality or malfunction. English Do not use anything other than the supplied AC adaptor and charging stand. Also, do not charge any other product with the supplied AC adaptor and charging stand. [. . . ] €•Do not charge, use, or leave the battery where it will be exposed to high temperatures, such as under direct sunlight or near other sources of heat. - Failure to do so may cause electric shock or fire due to electrical leakage resulting from insulation deterioration. WARNING After removing the rechargeable battery, do not keep it within reach of children and infants. Disconnect the adaptor or the appliance plug by holding onto the adaptor or the appliance plug instead of the cord. 7  English CAUTION ►Disposal of the rechargeable battery ► DANGER WARNING If the battery fluid leaks out, take the following procedures. - The battery fluid may cause blindness if it comes in contact with your eyes. - The battery fluid may cause inflammation or injury if it comes in contact with the skin or clothes. parts identification    π   12mm 15mm      • This clipper is designed for professional use to trim hair. € Before and after each use, apply oil at the places marked with arrows. ) • The clipper may become warm during operation and/or charging. 9  English Using the hair clipper English • Press the power switch to turn off the power. • We recommend using the clipper in an ambient temperature range of 5 - 35 °C. Using the comb attachments trimming heights 1 Select theon the insides and indicated dial to “0. 8” and 2 Set thethe attachment tothen mount the clipper as illustrated. Removing the attachment from the clipper Slide one side of the attachment off the mounting in direction indicated with the arrow. Use an attachment for a trimming height higher than 3 mm or more. 0 10 Care Removing and mounting the blade • Be sure to turn off the power before you remove the blade. Removing the blade Hold the clipper with the switch facing upward and push the blade with your thumb while catching the blade in your other hand. Brush the hairs out from between the stationary blade and the moving blade while pressing down on the cleaning lever to raise the moving blade. Fit the mounting hook into the blade mounting on the clipper and push in until it clicks. [. . . ] € Press the power switch to turn on the power and then keep the power on until the battery is completely discharged.       π      Can the battery be charged before every use? for environmental protection and recycling of materials This clipper contains a Lithium‑ion battery. Please make sure that the battery is disposed of at an officially assigned location, if there is one in your country. [. . . ]