User manual PANASONIC KXHNS105

[. . . ] A B C A Accessory item/Part number AC adaptor/PNLV2360Z DC extension cord/PNJA1159Z Wall mounting screws (25 mm (1 inch))/XTB4+25AVW B C Quantity 1 1 2 Other information R Design and specifications are subject to change without notice. R The illustrations in these instructions may vary slightly from the actual product. R Microsoft, Windows, and Internet Explorer are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. R All other trademarks identified herein are the property of their respective owners. [. . . ] Do not install the product on a ceiling, as the product may fall, resulting in damage or injury. ) R If the reception for a hub location is not satisfactory, move the hub to another location for better reception. Environment R Keep the product away from electrical noise generating devices, such as fluorescent lamps and motors. R The product should be kept free from excessive smoke, dust, high temperature, and vibration. R When you leave the product unused for a long period of time, unplug the product from the power outlet. R The product should be kept away from heat sources such as heaters, kitchen stoves, etc. It should not be placed in rooms where the temperature is less than 0 °C (32 °F) or greater than 40 °C (104 °F). R Operating the product near electrical appliances may cause interference. Other information Routine care R Wipe the outer surface of the product with a soft moist cloth. Pdf 6 2015/02/09 21:38:39 Setup Part names and functions LED indicator You can use the LED indicator to confirm the siren’s status. Indicator Green, lit Red, blinking slowly Red, blinking Red, blinking quickly Green, blinking Status Normal operation Siren is not registered to a hub Siren is out of range of the hub Alarm system was triggered Registration mode (You pressed and held M N) No power A B C D E Off F Setup overview 1 Initial setup Make sure you can access the system using your mobile device. R Insert the female plug of the DC extension cord (F) firmly into the AC adaptor plug (G). R Insert the grooves on the siren to the 4 tabs on the rear cover, and then push down the siren. 4 4 Note: While the siren is sounding or the strobe light is flashing, you can stop the siren by pressing M N. 3 8 2 1 6 7 5 Note about power connections AC adaptor connection R The AC adaptor must remain connected at all times. ) R The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. Pdf 11 2015/02/09 21:38:39 Appendix Testing the siren After you have installed the [Home Network] app on your mobile device, you can use your mobile device to test the siren. €“ Device management You can use the app to confirm the wireless signal strength of the siren, change the siren’s name, change whether the siren sounds, flashes, or both, and test the siren. Accessing the User’s Guide The User’s Guide is a collection of online documentation that helps you get the most out of the [Home Network] app. 1 iPhone®/iPad® Tap in the app’s home screen. Android™ devices Tap or press your mobile device’s menu button in the app’s home screen. [. . . ] For the hearing or speech impaired TTY: 1- 877-833-8855 For assistance, please visit www. Pdf 15 2015/02/09 21:38:39 Appendix Warranty (For United States and Puerto Rico) Panasonic Home Network System Products Limited Warranty Limited Warranty Coverage If your product does not work properly because of a defect in materials or workmanship, Panasonic Corporation of North America (referred to as “the warrantor”) will, for the length of the period indicated on the chart below, which starts with the date of original purchase (“Limited Warranty period”), at its option either (a) repair your product with new or refurbished parts, or (b) replace it with a new or a refurbished equivalent value product, or (c) refund your purchase price. The decision to repair, replace or refund will be made by the warrantor. Parts Labor Home Network System Products One (1) Year One (1) Year microSD card (Included model only) 90 days N/A During the “Labor” Limited Warranty period there will be no charge for labor. [. . . ]