User manual PANASONIC RPBTD5E

[. . . ] RP-BTD5 SQT0818 Dear customer Thank you for purchasing this product. Please read these instructions carefully before using this product, and save this manual for future use. 1 USB charging cord For the United Kingdom and Ireland customers Part names 1 LED indicator light* • The number of blinks or colour notifies the status of the unit. (* hereafter referred to as “LED”) 2 Power / Pairing button 3 Charging terminal (DC IN) • Connect the USB charging cord (supplied) to this terminal when charging. [. . . ] To end the phone call SQT0818 4 Press Call • The LED will repeatedly blink 2 times during a call. ENGLISH • There may be instances when hands free setting needs to be done on the Bluetooth® enabled phone. € Depending on the Bluetooth® enabled phone, you may hear incoming and outgoing call ringtones of the phone from the unit. € (HFP only) Press and hold the Call The calling device will be switched between the Bluetooth® enabled phone and the unit. 5 5 Safety precautions ■ Unit • Avoid using or placing this unit near sources of heat. € Do not listen with this unit at high volume in places where you need to hear sounds from the surrounding environment for safety, such as at railroad crossings, and construction sites. € Do not use solvents including benzine, thinner, alcohol, kitchen detergent, a chemical wiper, etc. This might cause the exterior case to be deformed or the coating to come off. WARNING: To reduce the risk of fire, electric shock or product damage, • Do not expose this unit to rain, moisture, dripping or splashing. € Do not place objects filled with liquids, such as vases, on this unit. Declaration of Conformity (DoC) ■ Allergies • Discontinue use if you experience discomfort with the speakers or any other parts that directly contact your skin. Hereby, “Panasonic Corporation” declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. But depending on the operating environment and/or settings, this security may not be sufficient. – Certification of this unit ■ Restrictions of use *1 It may be shorter depending on the operating conditions. The range can decrease depending on the environment, obstacles or interference. € This unit may not function properly and troubles such as noise and sound jumps may arise due to radio wave interference if this unit is located too close to other Bluetooth® devices or the devices that use the 2. € This unit may not function properly if radio waves from a nearby broadcasting station, etc. € Do not use this system near an equipment or in an environment that is sensitive to radio frequency interference (example: airports, hospitals, laboratories, etc). ■ Speaker section Driver units Impedance Φ 40 mm 32 Ω ■ Interference from other devices ■ Terminal section DC IN DC 5 V , 500 mA ■ Intended usage ■ Microphone section Type Mono ■ Accessory section USB charging cord 0. 7 7 Troubleshooting guide Before requesting service , make the following checks. If you are in doubt about some of the check points, or if the remedies indicated do not solve the problem, consult your dealer for instructions. Bluetooth® device connection The device cannot be connected • Delete the pairing information for this unit from the Bluetooth® device, then pair them again. [. . . ] 3) • Hvis lydstyrken af den anden persons stemme er for lav, kan man forøge lydstyrken for både enheden og den Bluetooth®-aktiverede telefon. I så fald opfylder det kravene for det direktiv, som er blevet fastlagt for det pågældende kemikalie. SQT0818 129 한국어 10 Safety information for customers in Finland and Norway NORSK ADVARSEL For å redusere risikoen for brann, elektrisk støt og produktskade: • Ikke utsett denne enheten for regn, fuktighet eller sprut. Subject to the conditions of this warranty Panasonic or its Authorised Service Centre will perform necessary service on the product without charge for parts or labour, if in the opinion of Panasonic, the product is found to be faulty within the warranty period. [. . . ]