User manual PANASONIC TX55CS620E

[. . . ] Please read these instructions carefully before operating this product and retain them for future reference. Please carefully read the “Safety Precautions” of this manual before use. Please refer to Pan European Guarantee Card if you need to contact your local Panasonic dealer for assistance. m0115-1015 TQB0E2503P42 English ● For information about the trademarks , refer to [eHELP] (Support > Licence). [. . . ] — Check the terminal type and cable plugs are correct for connection. ) or equipment with an infrared sensor, otherwise distortion of image / sound may occur or operation of other equipment may be affected. 3 B Removing the pedestal from the TV Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV. 1  emove the assembly screws R 3  emove the assembly screws R from the TV. ) E ■■Headphones ● To adjust volume  Headphone Volume] in the Sound Menu [ ● To select the sound output to adjust volume  Speaker Setting] in the Sound Menu [ TV (M3 stereo mini plug) ■■Common Interface ● Turn the TV off with Mains Power On / Off switch whenever inserting or removing the CI module. — If a smart card and a CI module come as a set, first insert the CI module, then insert the smart card into the CI module. — Insert or remove the CI module completely in the correct direction as shown. ) If encrypted channels do not appear  Common Interface] in the Setup Menu [ ● There might be some CI modules in the market with older firmware versions that do not work fully interoperable with this new CI+ v1. — For details, refer to [eHELP] (Functions > Common Interface), read the manual of the CI module, or check with the content provider. tV CI module 10 English Identifying Controls Remote Control ● Displays channel list. — Press after selecting channel positions to quickly change channel. English 11 ■■Installing / Removing batteries Pull open Hook 6 Volume Up / Down ● Cursor Left / Right (when in the menu system) 7 Mains power On / Off switch ● Use to switch the mains power. Close Note the correct polarity (+ or -) Indicator / Control panel ● When pressing 4, 5, 6 buttons, the control panel guide appears on the right side of the screen for 3 seconds to highlight which button has been pressed. 4 5 6 7 Rear side of the TV 1 2 3 1 Remote control signal receiver ● Do not place any objects between the TV remote control signal receiver and remote control. 2 Ambient sensor ● Senses brightness to adjust picture quality when [Ambient Sensor] in the Picture Menu is set to [On]. 3 Power LED Red: Standby Green: On Orange:  tandby with some functions (network S function , etc. ) active ● The LED blinks when the TV receives a command from the remote control. 4 Input mode selection ● Press repeatedly until you reach the desired mode. [Main Menu] ● Press and hold for about 3 seconds to display main menu. OK (when in the menu system) 5 Channel Up / Down ● Cursor Up / Down (when in the menu system) 12 English First time Auto Setup When the TV is turned on for the first time, it will automatically search for available TV channels and give options to set up the TV. — These steps are not necessary if the setup has been completed by your local dealer. 7 - 10) and settings (if necessary) of the connected equipment before starting Auto Setup. [. . . ] When pushed with a finger, the display panel moves slightly and makes a noise ● There is a little gap around the panel to prevent damage to the panel. 16 English Maintenance First, remove the mains plug from the mains socket. Display panel, Cabinet, Pedestal Regular care: Gently wipe the surface of the display panel, cabinet, or pedestal by using a soft cloth to remove dirt or fingerprints. F (2)  ampen a soft cloth with clean water or diluted D neutral detergent (1 part detergent to 100 parts water). [. . . ]