User manual PHILIPS AZ127

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the unit. Unplug this unit during lightning storms or when unused for long periods of time. Recording is permissible insofar as copyright or other rights of third parties are not infringed upon. [. . . ] When you disconnect the AC power, always pull the plug from the socket. Insert 6 batteries (type: 1. 5V R14/UM2/C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. •• Risk of product damage!Make sure that the power Connect the AC power cord to: • the AC~ MAINS socket on the unit. • the wall socket. Note •• To switch the unit off completely, disconnect the power cord from the power supply socket. EN 5 Turn on Press . »» When the source selector is in the AUDIO-IN/CD position, is displayed. Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes. • Press to wake up the unit from standby mode. Turn off Press again. 6 EN 4 Play Play a CD Note •• You cannot play CDs encoded with copyright protection technologies. You can play commercially available audio CDs: • CD-Recordables (CD-R) • CD-Rewritables (CD-RW) Play from an external device You can also listen to an external audio device through this unit. 1 2 3 4 • • • • Switch the source selector to AUDIO-IN/ CD. Insert a CD with the printed side facing up and close the CD lid gently. Connect an audio cable (3. 5mm, not supplied) to: • the AUDIO-IN socket on the unit. Play the external device (see the device's user manual). Note To select a track, press To pause CD play, press »» [ ] flashes. To resume CD play, press To stop CD play, press . 3 again. •• The AUDIO-IN socket is not for headphones. •• The display panel lights off when the unit plays from the external device. Audio-in EN 7 Play tape 1 2 3 4 Slide the source selector to TAPE. on main unit to open the tape Load the tape with the open side upward and the full spool to the right. [. . . ] No response from the unit •• Disconnect and reconnect the AC power plug, then turn on the system again. •• As a power-saving feature, the unit switches off automatically 15 minutes after track play reaches the end and no control is operated. Poor cassette sound quality • Ensure that heads in the cassette holder are clean. [. . . ]