User manual PHILIPS BT 7085/32

[. . . ] Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. -- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ENGLISH 5 -- Children should be supervised to ensure that they do not play with the appliance. -- Use, charge and store the appliance at a temperature between 5°C and 35°C. [. . . ] ENGLISH Using the appliance Display indications (BT7085/QT4070 only) The display is activated when you press the on/of button and when you turn the adjustment ring. -- During trimming, the display provides the following information: , , ’-’ when no comb is attached to the appliance. , , Travel lock indicator if the appliance is locked (see section ‘Travel lock’ in this chapter). Beard trimming Always comb your beard or moustache with a fine comb before you start trimming. 7 Trimming with trimming comb The hair length settings are indicated in millimetres on the display of the appliance. If you trim for the first time, start with the maximum hair length setting (18mm). 2 Turn the adjustment ring (Precision Zoom LockTM) to the desired hair length setting. Note: During trimming, you can use the turbo function for extra suction power and trimming speed (see section ‘Turbo function’ below). 8 ENGLISH 4 To trim most effectively, move the appliance against the direction of hair growth. Note: Make smooth and gentle movements and make sure the surface of the trimming comb always stays in contact with the skin. 5 Switch off the appliance after use and clean it (see chapter ‘Cleaning’). Creating a stubble look -- Use the trimmer with the trimming comb set to a hair length of 1mm to create a stubble look. Trimming without trimming comb Use the trimmer without trimming comb to trim full beards and single hairs. 2 Make well-controlled movements and touch the hair lightly with the cutting unit. Turbo function (BT7085/QT4070 only) You can use the turbo function for greater suction power and increased cutting speed. When you switch off the appliance, the turbo function is deactivated automatically. ENGLISH Absorbing cut hairs 9 The vacuum system is activated automatically as soon as you switch on the appliance. We advise you to empty the hair-collection chamber after each trimming session. When you trim long, dense beards, it may also be necessary to empty the hair-collection chamber during the trimming session in order to maintain optimal suction performance (see chapter ‘Cleaning’, section ‘Haircollection chamber’). Note:To ensure optimal functioning of the vacuum system, do not cut off more than approx. If you want to cut your beard shorter, repeat the process one or more times. Travel lock (BT7085/QT4070 only) You can lock the appliance when you are going to travel. [. . . ] 4 Pull the hair-collection chamber out of the appliance with some force. 5 To remove the front panel, wedge a screwdriver between the front panel and the inside of the appliance. 8 Remove the printed circuit board with the rechargeable battery connected to it. 9 Cut the wires between the printed circuit board and the rechargeable battery. [. . . ]