User manual PHILIPS FC9308/01

[. . . ] νικα 53 Español 69 Suomi 85 Français 100 Italiano 116 Nederlands 132 Norsk 148 Português 164 Svenska 180 Türkçe 196 FC9308 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. This vacuum cleaner’s extremely efficient motor produces less noise than other types and yields a high performance at a low power consumption. €1) 1 On/off button 2 Infrared receiver 3 Cord rewind button 4 Dustbag-full indicator 5 Hose release buttons 6 Hose connection opening 7 Cover release tab 8 Motor protection filter holder 9 Dustbag holder 10 Dustbag 11 Infrared remote control 12 Ergonomic ComfortControl handgrip 13 Flexible hose connection 14 Hose 15 Crevice tool 16 Accessory holder release levers 17 Accessory holder 18 Small nozzle with brush attachment 19 Tube release button 20 3-piece telescopic tube 21 SilentStar nozzle 22 Rocker switch for carpet/hard floor settings 23 HEPA 13 washable filter 24 Filter cover 25 Mains plug 26 Parking slot 27 Release button of filter cover 28 Storage grip 29 Swivel wheel 30 Parking/storage ridge 31 Type plate 32 Rear wheels  Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] Note:The functions on the remote control only work after you have switched on the appliance with the on/off switch on the appliance itself. € Note: Replace the batteries when the ‘infrared active light’ does not light up when you press any button. Using the appliance 1 Pull the cord out of the appliance and put the mains plug in the wall socket. 2 To switch on the appliance, press the on/off button on top of the appliance. Tip:To avoid bending your back, press the on/off button with your foot. 3 To switch off the appliance, press the on/off button on top of the appliance. Adjusting suction power 1 During vacuuming, you can adjust the suction power level with the – and + buttons on the remote control. English -- Use maximum suction power to vacuum very dirty carpets and hard floors. 13 -- Use minimum suction power to vacuum curtains , tablecloths etc. Pausing during use 1 If you want to stop vacuum cleaning for a moment, press the standby button on the remote control to switch off the appliance temporarily. If your appliance has no remote control, press the on/off button on top of the appliance to Usswitch off the appliance. 2 Insert the ridge on the nozzle into the parking slot to park the tube in a convenient position. 3 To ensure stable parking of the telescopic tube, adjust the tube to the shortest length. 4 To continue vacuum cleaning, simply press the standby button on the remote control again. If your appliance has no remote control, press the on/off button on top of the appliance to switch on the appliance. Storage 1 Switch off the appliance and remove the mains plug from the wall socket. 14 English 2 Press the cord rewind button to rewind the mains cord. To attach the nozzle to the appliance,  insert the ridge on the nozzle into the storage slot. -- To ensure stable parking of the telescopic tube, adjust the tube to the shortest length. Tip:We advise you to wrap the hose around the tube to ensure stable parking and to save even more space when you store the appliance. Replacing the dustbag Tip:We advise you to clean the motor protection filter every time you replace the dustbag (see chapter ‘Cleaning and maintenance of filters’). Always unplug the appliance before you replace the disposable dustbag. [. . . ] Switch on the vacuum cleaner to force the air through the blocked-up item in opposite direction. A Perhaps the batteries do not make proper contact or have not been inserted in the proper way. -- Remove the lid of the battery compartment and push the batteries back into place. The lower the air humidity in the rooms, the more static electricity the appliance builds up. [. . . ]