User manual PHILIPS TD6120

[. . . ] The marking on the product certifies its conformity to the technical regulations for user safety and electromagnetic disturbance which were applicable on the date of approval in accordance with European Union directive No. POWER REQUIREMENTS This product requires an electrical supply of 220-240 volts, alternating monophased current, excluding IT installations defined in standard EN 60-950. The electrical network is classified as dangerous according to criteria in the standard EN60-950. The only way to power down this product is by unplugging the power cable from the electrical outlet. [. . . ] The batteries contain cadmium and should be disposed of in accordance with the regulations in force concerning the disposal of waste. The manufacturer disclaims all responsibility if these recommendations are not respected. Cd CONNECTING THE TELEPHONE 1 2 At the back of the base station: 1 Connect the mains adapter cable to the base station, then plug the mains adapter into the wall socket. 2 Connect the telephone cable to the base station and then to the wall socket. Place the telephone handset on the base station and allow the batteries to charge for at least 12 hours. 3 To remove the colour clip, pull it out from the Philips marking. 3 DESCRIPTION HANDSET DISPLAY Numerical characters Telephone icons ICON STATE Displayed Batteries charged. Blinking Displayed Blinking Displayed Displayed Blinking Displayed Blinking Displayed Not displayed Blinking DESCRIPTION Handset being charged. Waiting for an answer from the base station (in the context of registration). Handset not registered with the base station. 4 DESCRIPTION TELEPHONE LEDS The base station has a green LED: - Lit, when the base station is powered. AUDIBLE SIGNALS Your telephone emits: - 1 short beep - 1 long beep - 2 beeps - 3 beeps = when you press a key. = when these is no contact between the handset and the base station any other problem occurs (if you make a mistake). = to indicate that the handset needs to be recharged = when you place the handset on the base station. = in the programming phase, inviting you to continue with the procedure. RINGER EQUIVALENCE NUMBER OR REN (UK ONLY) Your has a Ringer Equivalence Number (REN) of 1. 0. To determine the maximum number of telephones that can be connected to your line, add together the individual RENs of all the apparatus you wish to connect. If this total exceeds four, one or all of your telephones may not ring correctly. 5 USING YOUR TELEPHONE Your Philips telephone is GAP certified, nevertheless we cannot guarantee its use with DECT products made by other manufacturers. You can register 4 handsets with 1 base station and 1 handset with 2 base stations. TO MAKE A CALL TO ANSWER A CALL Dial the number Speak Hang up Connect the line The duration of the call is displayed. Your telephone rings Conned the line The duration of the call is displayed. TO REDIAL THE LAST NUMBER Speak Hang up Connect the line Hang up Press the Speak Redial key* * The last telephone number dialled is displayed and the call made. TO PROGRAMME A NUMBER FOR THE SOS KEY Dial the number you want to register Programme To dial the 'SOS' number, press Press then Confirm , the number is dialled automatically. 6 USING YOUR TELEPHONE TO ADJUST THE EARPIECE VOLUME Your telephones handset is equipped with adjustable earpiece volume (3 levels). [. . . ] PROBLEM CAUSE SOLUTION Check the connections. The LED on the base station is The base station has not been not lit. No audible signal is transmitted when you place the handset on the base station. u The charging contacts are dirty. u Pick up the handset and the replace it. u Clean them with a clean dry cloth. u u u The base station has not been connected to the telephone line correctly. [. . . ]