User manual PROGRESS B3107

[. . . ] If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. · Do not pull or carry by cord, use cord as a handle, close door on cord. · Do not use extension cords or outlets with inadequate current carrying capacity. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth-connection is necessary. ] It is in you interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot In no circumstances must be plug be used with- regard the repair of faults on the plug connection as a out a correct fuse cover fitted. service that can be given free of charge under the If the plug that is fitted to your appliance is not suitable terms of guarantee. for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off As a general guide to fitting any plug. The cutoff plug should then be disposed of to · Ensure the lengths of wire inside the plug are preprevent hazard of shocks in case it should be plugged pared correctly. into a 13 Amp socket in another part of your home · Connection should be firmly made after all conductor stands are entered into the terminal posts. The wires in the mains cable of this appliance are · When preparing the cable ends take care not to coloured in accordance with the following code: damage the outer seal, or insulation surrounding the Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: SAVE THESE INSTRUCTIONS The Electrolux Group, 101 Oakley Road, LUTON, BEDFORDSHIRE, LU4 9QQ Features of the BOSS vacuum cleaner and accessories with it are protected in Great Britain and abroad by Patents of Registered Designs. The Electrolux Group may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteretion without notice. 3106 · 3107 · 3116 3106 · 3107 · 3116 MAINTENANCE REPLACING THE DUSTBAG Always operate the cleaner with the dustbag installed. If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely. After removing the flexible hose, open the front cover using the compartment open button. 20) The dustbag reference number is U62 BLOCKED AIRFLOW AND DIRTY FILTERS The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt. Disconnect from mains and allow the cleaner to cool for 45-60 minutes. REPLACING THE FILTERS The dustbag must be replaced if the window of the dustbag full indicator is illuminated when the cleaner is operating at maximum power and the nozzle is raised from the floor. Filters should be replaced at least twice a year or when they become visibly soiled. Always operate the cleaners with filters installed to avoid reduced suction. Replacing the motor filter Pull dustbag upward and remove the motor protection filter. [. . . ] Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations. Do not use the appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts. Do not vacuum up any highly flammable or explosive substances or gases. Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc. [. . . ]