User manual PROGRESS B4300

[. . . ] If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. · Do not pull or carry by cord, use cord as a handle, close door on cord. · Do not use extension cords or outlets with inadequate current carrying capacity. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow. [. . . ] [This cleaner is double insulated and no earth-connection is necessary. ] It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualified electrician, as Electrolux cannot regard the In no circumstances must the plug be used with- repair of faults on the plug connection as a service that out a correct fuse cover fitted. can be given free of charge under the terms of guarIf the plug that is fitted to your appliance is not suitable antee. for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off As a general guide to fitting any plug plug. The cut off plug should then be disposed of to · Ensure that the lengths of wire inside the plug are prevent hazard of shocks in case it should be plugged prepared correctly. · Connection should be firmly made after all conductor stands are entered into the terminal posts. The wires in the mains cable of this appliance are · When preparing the cable ends take care not to damcoloured in accordance with the following code: age the outer seal, or insulation surrounding the inner Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to SAVE THESE INSTRUCTIONS The Electrolux Group, 101 Oakley Road, LUTON, BEDFORDSHIRE, LU4 9QQ Features of the BOSS vacuum cleaner and accessories with it are protected in Great Britain and abroad by Patents of Registered Designs. The Electrolux Group may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteretion without notice. ifu_B4300_4. qxp 8/10/2001 10:51 AM Page 7 B4300 B4300 MAINTENANCE 19. 21 REPLACING THE DUSTBAG Ø Always operate the cleaner with the dustbag installed. Ø If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely. Ø The dustbag must be replaced if the window of the dustbag full indicator is illuminated. Ø After removing the flexible hose, open the front cover using the compartment open button (fig. BLOCKED AIRFLOW AND DIRTY FILTERS Ø The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt. Ø Disconnect from mains and allow the cleaner to cool for 45-60 minutes. REPLACING THE FILTERS Ø Filters should be replaced at least twice a year or when they become visibly soiled. Ø Always operate the cleaners with filters installed to avoid reduced suction. Replacing the motor filter Ø Pull dustbag upward and remove the motor protection filter (fig. Ø Rinse the filter under tap water and dry it completely (fig. 24). [. . . ] Ø Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations. Ø Do not use the appliance on wet surfaces or to vacuum liquids. Ø Do not vacuum up very fine dust from plaster, cement, cold cinders, flour or ash. Ø Do not vacuum up any highly flammable or explosive substances or gases. [. . . ]