User manual PROGRESS DELPH841E

[. . . ] The cleaner is double insulated so it must not be earthed The cleaner is only to be used by adults Always store in a dry place Do not use to pick up liquids Avoid sharp objects Do not pick up hot cinders or lighted cigarette ends Do not use near flammable gases Avoid tugging on the mains cable and check cable regularly for damage Note: Do not use cleaner with a damaged cable. If damaged the cable should be replaced at a service centre The plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised service staff On/off cover button Parking position for tube and nozzle when in use Storage slot for tube and nozzle when not in use Carpets: Use floor nozzle with lever in this position. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. [. . . ] S-bagTM indicator and changing the s-bagTM For peak performance the s-bagTM should be changed when full. The mechanical s-bagTM indicator window will gradually turn red when filling and completely red when full. If the dust bag should get broken in the cleaner, take cleaner to service centre for cleaning. The s-bagTM full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. To check the s-bagTM, the cleaner must be switched on, with all attachments connected and off the floor. 9 Lift and pull the sliding tab to remove the s-bagTM from its holder. We recommend the s-bagTM is changed after using a carpet cleaning powder or if there is a bad smell from the cleaner. Using the Turbo nozzle (some models) Precautions: Only use the nozzle on carpets with a pile depth of under 15 mm. To avoid damaging your carpet, do not keep nozzle stationary whilst brush is rotating. Do not pass nozzle over mains cable and switch off nozzle immediately after use. Cleaning the Turbo nozzle: 22 Disconnect from mains and remove entangled threads from brush by snipping with scissors. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. The cleaner may switch itself off in event of severe blockage or excessively dirty filters. In such cases, disconnect from mains and allow to cool for 30 minutes. [. . . ] The cleaner may switch itself off in event of severe blockage or excessively dirty filters. In such cases, disconnect from mains and allow to cool for 30 minutes. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. [. . . ]