User manual PROGRESS PC7270

[. . . ] Ø Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate. Ø Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug. [. . . ] To connect the hose into the suction inlet push it until it clicks (fig. To disconnect the hose from the suction inlet push the button at the end of the hose (fig. Unwind a sufficient length of cable and insert the plug into the power socket. On initial start up full power is reached after approximately 1-2 seconds. Ø To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing damage. Ø By moving the variable power control, the suction power can be adjusted. The dust container must be emptied if the window of the dust container indicator changes into red when the cleaner is operating at maximum power and the nozzle is raised from the floor. Remove the filter set from the dust container by taking it in the way indicated in the icon (fig. Filters should be replaced at least twice a year or when they become visibly soiled. Always operate the cleaner with filters installed to avoid reduced suction. Ø Remove the filter set from the dust container by taking it as indicated in the icon (fig. Ø Remove the cartridge filter by turning it counter - clockwise (A) and pull it out (B) as indicated in the icon (fig. [. . . ] Blocked air flow and dirty filters The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt. Disconnect from mains and allow the cleaner to cool for 20-30 minutes. [. . . ]