User manual PROGRESS PI3550X

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 69 70 71 72 73 74 74 75 76 78 79 80 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Use of combi detergent tablets These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents Depending on which kind of tablets you choose ('3 in 1', '4 in 1', '5 in 1' etc. The refilling of the salt container and the rinse aid dispenser are no longer necessary. In this case the rinse aid indicator light will always remain on when the machine is switched on. Press function button B, the lights of function buttons A and C go off while the Light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light comes on, indicating that the rinse aid dispenser has been activated. To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. the phase indicator lights foreseen for the set programme start flashing. Once the programme starts, the phase indicator lights go off except for the indicator light of the phase in progress which will remain on with a static light. After having selected the washing programme, press the delay start button until the light corresponding to the chosen hours flashes (3h, 6h or 9h). Close the door; the countdown will continue from the point at which it was interrupted. The selection of the washing programme and delay start can also occur with the door closed. Keep in mind that in this way, once a washing programme button is pressed you have ONLY 3 seconds in which you can choose another programme or select a delay start, after which the selected programme will start automatically. Simultaneously press and hold the two function buttons B and C until all the programme lights go off. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Close the door; the programme will start from the point at which it was interrupted. Press the On/Off button again; the programme will start from the point at which it was interrupted. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by the Service Force Centre. Water drain connection The end of the drain hose can be connected in the following ways: 1. [. . . ]