User manual PSE ARCHERY HYPERLITE POCKET

[. . . ] 2/10/06 The new HyperliteTM Pocket System is unlike that on any other bow. [. . . ] IMPORTANT: Do not "bottom" the limbs against the riser on a bow equipped with the HyperliteTM Pocket System!Traditional limb pockets use a "bottomed" position to determine peak weight. This position is where the limb, pocket and riser contact one another simultaneously. Due to the compact design of the HyperliteTM Pocket System, the "bottomed" limb position does not exist. The "bottomed" position for HyperliteTM pockets is where the bottom surface of the limb is approximately . 20" (3/16" or 5 mm) away from the riser (Figure 2). The limb bolt may be adjusted to slightly increase the draw weight, but the gap between the limb and riser must never be less than . 15" (4 mm). IMPORTANT: Loosen the barrel location set screw before making weight or tiller adjustments to a bow equipped with the HyperliteTM Pocket System!Some bows equipped with the HyperliteTM Pocket System use a barrel-locating setscrew (Figure 3). [. . . ] DO NOT ADJUST! · Figure 1 Limb Bolt Setscrew · Figure 2 Barrel Location Setscrew Limb Bolt Set Screw Limb Bolt Barrel Figure 4 Groove Figure 3 [. . . ]