User manual REMINGTON DT-800

[. . . ] S Close supervision is necessary when this appliance is used by, on, or near children or invalids. S Use this appliance only for its intended use as described in this manual. S Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water. If any of these things happen, return the appliance to a Remington authorized service center for examination and repair. [. . . ] s Charge the Tangle TamerTM at temperatures between 40-90° F , to avoid decreasing the battery life. Be sure the Tangle TamerTM is turned off before attaching the power cord. Plug one end of the cord into the back of the Tangle TamerTM, then plug the other end into an electrical outlet. CAUTION: Children should always be supervised when using an electrical appliance. Use the Tangle TamerTMmuch like you would use a normal comb, on wet or dry hair. Avoid rubbing hair with towel--this creates split ends and frizziness. Place the Tangle TamerTM in the hair just below your hand and ease it through the hair to the ends using short strokes. Move your hand to grasp the section of hair a few inches higher, and repeat the process. Gradually work your way up the section of hair like this until you can run the Tangle TamerTM smoothly from the roots to the ends. The Tangle TamerTM should glide easily through wet or dry hair, so do not tr y to force it. If you come across a difficult tangle, simply take the Tangle TamerTM out of hair and start again. Repeat for each section of hair, until all the tangles have been combed through. S Clean the teeth and handle of the Tangle TamerTM with a soft, damp cloth. S After the Tangle TamerTM has been cleaned, replace its comb cover and return it to its storage stand. cAUTION: THESE NICKELCADMIUM BATTERIES MUST BE RECYCLED OR DISPOSED OF IN ACCORDANCE WITH STATE AND LOCAL REGULATIONS. Do not burn or mutilate, as they may burst or release toxic materials. Is voluntarily participating in an industry program to collect and rec ycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY SM for information on Ni-Cd batter y recycling and disposal bans/restriction in your area. 's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. [. . . ] When your Tangle TamerTM reaches the end of its useful life, the battery must be removed and recycled or disposed of properly. The following procedure should be followed for battery removal: s Make sure the Tangle TamerTM is unplugged from any outlets so you don't risk an electric shock. S Remove the back pink plate with a small, flat screwdriver s Using a small Phillips head screwdriver, remove the three screws from the back of the Tangle Tamer. Never wrap the cord around the appliance as this will cause the cord to wear prematurely and break. [. . . ]