User manual SAECO LIRIKA

[. . . ] 02 ENGLISH Type SUP041E 02 EN OPERATING INSTRUCTIONS Read these operating instructions carefully before using the machine. Com manuals search engine 1 1 2 3 7 8 4 5 6 9 10 11 12 13 14 15 16 17 18 19 20 21 •2• 22 23 24 25 Downloaded from www. Com manuals search engine 2 3 4 5 6 7 8 9 10 11 12 13 •3• Downloaded from www. Never allow water to come into contact with any of the electrical parts of the machine: danger of short circuit! [. . . ] After this time the message "Refill the coffee bean hopper with coffee beans and restart the cycle" appears. If this signal appears again, contact the service provider and quote the code shown on the display. Com manuals search engine Machine Installation - Service Provider Manual 8 HANDLING AND STORAGE • All the operations described in chapter 8 must be performed exclusively by the service provider or a specialised technician, who shall organise all the operating steps and use only suitable means to ensure strict compliance with the safety regulations in force. 1 Handling • During handling and transportation, the machine must be kept in an upright position, according to the instructions printed on the packaging. Make sure that nobody is standing in the area during load lifting and handling. 2 Storage • The machine should be stored in accordance with the following conditions: - Minimum temperature: above 4°C; - Maximum temperature: below 40°C; - Maximum humidity: below 95%. Due to the total weight of the packaged product, do not stack more than three machines on top of each other. The machine should be stored in its original packaging, in a dry and/or dust-FREE place. €¢ 9 INSTALLATION All the operations described in chapter 9 must be performed exclusively by the service provider or a specialised technician, who shall organise all the operating steps and use only suitable means to ensure strict compliance with the safety regulations in force. The machine should be connected to the mains according to the safety regulations in force in the country where the machine is used. Connection to the drinking water network (for water-network supplied machines) should be made in compliance with the safety regulations in force in the country where the machine is to be used. The socket to which the machine is connected should be: - compatible with the type of plug installed on the machine; - suitably sized to comply with the data on the plate attached to the bottom of the appliance; - connected to an efficient earthing system. The power cord should not: - come into contact with any type of liquid: danger of electric shocks and/or fire; - be crushed and/or come into contact with sharp surfaces; - be used to move the machine; - be used if damaged; - be handled with damp or wet hands; - be wound in a coil when the machine is in use; - be tampered with. If the power cord is damaged, it must be replaced by the manufacturer or an authorised service centre, or in any case by a person with a similar qualification. It is forbidden to: - Install the machine other than as described in Chapter 9, or outdoors. - Use the machine in any manner other than as described in this manual. - Use the machine in explosive or harsh environments, or with high concentrations of dust or oily substances suspended in the air. - Use the machine to dispense products other than those it is designed for. Com manuals search engine Machine Installation - Service Provider Manual • Before cleaning the machine, ensure the plug is disconnected from the power socket; do not wash it with fuel and/or solvents of any kind. Do not place the machine near heating equipment (such as heaters or radiators). 1 List of Accessories Supplied Manual: instructions on how to use the machine. "Intenza +" water filter: to remove any unpleasant flavours in the water and reduce water hardness. [. . . ] Com manuals search engine Machine Installation - Service Provider Manual 12 MACHINE DISPOSAL In compliance with art. 151 "Implementation of the Directives 2002/95/ EC, 2002/96/EC and 2003/108/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment, as well as waste disposal". The symbol of the crossed-out wheeled bin on the appliance or its packaging indicates that the product must be disposed of separately from other waste at the end of its operational life. The user must therefore take the appliance to be disposed of to a suitable recycling centre for electronic and electrotechnical equipment, or alternatively hand it over to the vendor on a one on one exchange, when purchasing a new appliance of similar type. [. . . ]