User manual SAMSUNG DV50F9A8EVP/AC

[. . . ] Imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service or accessory parts, please register your product at or contact www. Extra Large Capacity Ultra drying capabilities are at your fingertips!Ft capacity dryers circulate more air through your clothes, drying them faster, for a wrinkle-free result. [. . . ] Using pliers, tighten the coupling with an additional two-thirds turn. Check for leaks around “Y” connector, faucets and hoses. You have used rigid or stiff-walled flexible metal duct material, not plastic flexible duct. Indd 19 2013-1-25 9:26:49 installing your dryer Vent blockage test (DV50F9A7E(G)*, DV50F9A6E(G)*) After the dryer is installed, start the Test to check if the exhaust system is applicable for the dryer. Vent Blockage Test detects duct state of the dryer automatically and report blockage state of the duct to the user. Proper duct state can help users to reduce drying time and save energy. If it warms up after installation check, Run the Air fluff cycle for several minutes, so as to reduce its internal temperature. (If there is any clothes or other item in the drum, correct diagnosis can’t be made. Press the power button to turn the dryer on, then press and hold both the Adjust time Up and Dry level buttons simultaneously for 3 seconds. When entering the Test mode, “InS” will appear in the display. (If other procedure is started before entering the Test mode, it’s unable to enter the Test mode. Starting diagnosis immediately after pressing the Start button, During diagnosis, the operation state is displayed in the form of “0000“. If state of the exhaust system is normal, “End” appears and completion sounds is given. If the exhaust system can’t exhaust smoothly, “CLg” appears and alarm sounds is given. In case of any other problem, error code appears; Check the information codes in this manual. * In order to stop or cancel the diagnosis mode, press the power button to turn off your dryer. During or after diagnosis, the internal drum is hot; Be careful and don’t be scalded. Vent Blockage Test is used to check if there is some problem to the current exhaust system when the dryer is set for the first time. If the diagnosis result displays “CLg” (the exhaust system is blocked ), refer to “DUCTING REQUIREMENTS” and “DRYER EXHAUST TIPS” section of this manual and take proper measures for drying. Even if the diagnosis result is normal (“End”), the exhaust system may also be interrupted or blocked slightly. Indd 21 2013-1-25 9:26:50 installing your dryer Door Reversal If you want to reverse the direction of the door, it is recommended calling a qualified service technician. Remove the two screws from the holder-lever, and then remove the cover-holder. [. . . ] Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific rights, and you may also have other rights, which vary from state to state. Com Visits by a Service Engineer to explain functions, maintenance or installation is not covered by warranty. Please contact your Samsung call agent for help with any of these issues. [. . . ]