User manual SIEMENS GIGASET DA310

[. . . ] Lift out the handset bracket (5) with a screwdriver and clip it into the handset cradle (6). Please note: The handset bracket must be placed in the cradle with the slanting edge facing forwards (see graphic), as otherwise the handset will not be properly secured. [. . . ] u Dialling a dialling pause within the first 5 digits: The entire number saved is dialled, including the 2-second dialling pause. u Dialling a dialling pause after the first 5 digits: The portion of the number saved after the pause is only dialled after pressing the I key. 2 4 5 M N low medium 3 L O high Operation on a PABX Special functions/Recall key During an external call, you can make an enquiry or forward the call. To set the recall key, the telephone’s flash time must be set consistent with your PABX. Please refer to the operating instructions for your PABX. Adjusting the telephone Setting the handset volume The handset volume can be set to two levels. The primary volume is reset after hanging up. Changing the dialling mode/ flash time The telephone supports the following dialling modes: T2: Tone dialling, flash time 280/ 600 ms (depending on device model) Mute You can deactivate the telephone's microphone during a call. T1: Tone dialling, flash time 100 ms P: Pulse dialling Gigaset DA310 /IM-MEA en / A30054-M6528-A601-1-UZ19 / DA310_en. fm / 03. 08. 2011 5 en Depending on your PABX, you may need to change your telephone’s dialling mode or the flash time. To do this, use the sliding switch on the underside of the device. Appendix Care Wipe the unit with a damp cloth or an antistatic cloth. Never use a dry cloth; this can cause static. Temporary tone dialling switching in "Pulse" position To use functions that require tone dialling (e. g. remote control of answering machine), you can set the telephone to tone dialling for the duration of the call without adjusting the switch. After the connection is broken, the setting reverts to pulse dialling. Contact with liquid ! If the device comes into contact with liquid: 1 Allow the liquid to drain from the device. Place the device (the keypad facing down) in a dry, warm place for at least 72 hours (not in a microwave, oven etc. ). When it has fully dried out, you will normally be able to use it again. In rare cases, contact with chemical substances can cause changes to the telephone's exterior. Due to the wide variety of chemical products available on the market, it was not possible to test all substances. Operation on public telephone systems Public telephone systems - in some cases by special order/request – offer you a range of useful additional services (e. g. These services can be selected using specified key combinations, which your network provider will notify you of. [. . . ] A copy of the 1999/5/EC Declaration of Conformity is available at this Internet address: www. gigaset. com/docs Environmental management system Gigaset Communications GmbH is certified according to the international standards EN 14001 and ISO 9001. ISO 14001 (Environment): Certified since September 2007 by TüV SÜD Management Service GmbH. [. . . ]