User manual SKIL 2364

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. [. . . ] If liquid comes in contact with skin, wash quickly with soap and water. If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging battery pack. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. If smoke or melting of the case are observed unplug the charger immediately and do not use the battery pack or charger. Use of an attachment not recommended or sold by Skil may result in a risk of fire, electric shock or injury to persons. For example, to protect terminals from shorting DONOT place batteries in a tool box or pocket with nails, screws, keys, etc. WARNING semble the battery or remove any component projecting from the battery terminals. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. LITHIUM-ION BATTERIES If equipped with a lithium-ion battery, the battery must be collected, recycled or disposed of in an environmentally sound manner. "The EPA certified RBRC Battery Recycling Seal on the lithium-ion (Li-ion) battery indicates Robert Bosch Tool Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alterative to placing used Li-ion batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Li-ion battery recycling and disposal bans/restrictions in your area, or return your batteries to a Skil/Bosch/Dremel Service Center for recycling. Robert Bosch Tool Corporation's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. CAUTION completely discharged before attempting to remove battery from your tool. Wrap heavy insulating tape around battery terminals or enclose in a sealable plastic bag to prevent possible shorting. Dispose of battery through your local waste removal authority or a Skil Service Center. Proper interpretation of these symbols will allow you to operate the tool better and safer. For reverse rotation move the lever to the far right and the green indicator light depicting a reverse arrow will light up. The drill " " position will lock up the clutch to permit drilling and driving heavy duty work, and also enables bits to be changed quickly and easily in the keyless chuck (Fig. This is especially useful in the repetitive driving and removal of screws. gEAR SHIFTING Your tool is equipped with two separate gear ranges , Hi-torque and High-speed. [. . . ] The lithium ion battery can be charged at any time without reducing its service life. A battery that is new or has not been used for a longer period does not develop its full capacity until after approx. Completely charge the battery before using Insert the connector pin into hole provided in rear end of handle, then plug the charger into the power source (Fig. When the fuel gauge LED stops "BLINKING" and turns off, charging is complete. [. . . ]