User manual SUNBEAM GCSBCS-1

[. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800 458-8407 and a convenient service center address will be provided to you. In Canada If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800 667-8623and a convenient service center address will be provided to you. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1. [. . . ] To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet, reverse the plug. If an extension cord is absolutely necessary, a 15-ampere cord should be used. Care should be taken to arrange the extension cord so that it cannot be pulled or tripped over. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. Do not set the iron on an unprotected surface, even if it is on its heel rest. If the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center. Use caution when you turn a steam iron upside down ­ there may be hot water in the reservoir. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while plugged in or turned on or on an ironing board. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. Plug in the iron, set the Fabric Select Dial to Linen and allow the iron to heat for 2 minutes. When rocking the iron, dip the nose of the iron slightly below the rear of the iron to make certain the water circulates completely. Open the fill cap, turn the iron upside down, and allow the remaining water to flow out of the fill hole. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. IMPORTANT: When not ironing, always set the Steam Lever to (Dry) and the Fabric Select Dial to OFF. You can use this feature while Dry or Steam ironing, as long as the Fabric Select Dial is set to wool, cotton, or linen. TO USE THE SHOT OF STEAM® FEATURE: Place the iron on top of the wrinkle and press the Shot of Steam® button each time you would like an extra burst of steam. The Shot of Steam® feature may be used continuously in approximately 3-second intervals. When the iron is plugged in, the Auto-Off activates automatically after 30 minutes. Once the Auto-Off activates, the power indicator light will turn off and the iron stops heating. then move the Variable Steam Lever to (Dry) and the Fabric Select Slider to Off. [. . . ] WARNING: The Auto-Off is a safety feature and is not a recommended means for turning your iron off. When the iron is plugged in, the Power Indicator will light steadily, indicating that there is power to the iron. yOU LEAVE THE IRON: · In a horizontal position without moving it, or accidentally tip the iron over, it will automatically stop heating after 30 seconds. The Power Indicator will blink to let you know that the iron has stopped heating. [. . . ]