User manual SUNBEAM KY-25/Y

[. . . ] We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING". These words mean: You can be killed or seriously injured if you don't immediately follow instructions. [. . . ] B) Screw the exhaust ducts clockwise with one end to the terminal end of the back of the unit and the other end to the window kit adapter. E) Adjust the length of the window kit to the same length of the window or the sliding door. Cut the window piece as needed to fit the length of your window or sliding door. Make sure that the hole on the main piece is not covered by other pieces. G) Adjust the length of exhaust duct and affix the window kit adapter onto the holes on the window kit. NOTE: When using the window kit on a window or sliding door it will cause the window or sliding door to not be properly closed and/or locked. 22cm in diameter in the wall; attach the other end to the back of the unit (same as above). B) Use the exhaust outlet wall covers to cover the holes in the wall when the unit is not in use. Take care to prevent any kind of bend in the middle of the exhaust hose, as this will trap hot exhaust air, which will radiate back into the room and affect the cooling function of the unit (Fig. The length of the exhaust pipe is specially designed according to the specification of this product. Do not replace or extend it with your own hose as this could cause the unit to malfunction (Fig. If the unit is turned off during operation please wait at least three minutes before starting it again. "Up" or "Down": Temperature or Time Changing Button: Use these two buttons to set to your desired temperature. The temperature unit will be changed from Fahrenheit to Centigrade or vice versa. During the timer set-up, these buttons are also used to change the time. timer Setting or Cancel Button: Use to set or cancel TIMER-ON or TIMER-OFF timer. After these ten (10) seconds the digits will change to display your selected time delay. When the unit is OFF, if it hasn't been set on Time Delay, press the Timer button. When you are setting the time, the other settings like Operation Mode, Fan Mode, or Set Temperature, will also display. Ten (10) seconds later, these modes will disappear but be remembered by the Main Controller. HOW TO CANCEL: When the unit is set with the TIMER-OFF or the TIMER-ON procedures, press the the Timer set time, then press within ten (10) seconds to cancel the timer setting. You can operate the unit either on the Control Panel or with the Remote Control. [. . . ] (hereinafter referred to as SE/EG) hereby warrants, subject to the conditions herein stated in the paragraphs below, that should this product become defective by reason of improper workmanship or material defect during the specified warranty period, SE/EG will repair or refund the same effecting all necessary parts replacements. Transportation charges on parts submitted for repair or refund, under this warranty, must be borne by the purchaser. SE/EG warrants that from the date of purchase, this product will be free from mechanical defects for a period of one (1) year and a period of ninety (90) days on parts and labor. SE/EG, at its option, will repair or refund this product found to be defective during the warranty period. [. . . ]