User manual ULTIMATE SPEED KH 3017 HYDRAULIC CAR JACK

[. . . ] If the required force exceeds 400 N, these forces must be diminished by enlisting additional people. J not allow the hydraulic vehicle jack to be used by uninstructed Do J Before using the hydraulic vehicle jack take precautions to prevent J J J J Even with precautions in place always remain alert and make a visual check that the saddle 1 is firmly seated against the vehicle jacking point. [. . . ] The following is / are forbidden: - Operation under difficult conditions - Operation that is subject to special provisions - The handling of loads whose properties could lead to dangerous situations - Dangers that arise during dismantling - Direct contact with food - Operation on ocean-going vessels Follow the instructions below to avoid the threat of loss of life, injury, or damage to the product etc. J Always use axle stands and wheel chocks in addition to your hy- 1 Hydraulic car jack 2 Tube sections with locating slot 1 Tube section with locating pin 1 Operating instructions Never work under a raised vehicle unless you have taken additional safety precautions. This is intended to prevent the vehicle from rolling away, sliding off or overturning the jack. Using the product Use on an unstable or uneven surface ­ such as a gravel surface ­ may lead to the load slipping. Person operating the jack must observe the jack and the load The during all movements. Never work under the raised load if it has not been made secure by suitable means. Follow these steps: j lace one of the tube sections with a locating slot 6 on to the P release valve 5 and turn it in the direction (see Fig. j lace the hydraulic vehicle jack under one of the lifting positions as P shown in the owner's manual supplied by the vehicle manufacturer. J crew out the extension screw 2 in the S direction until the saddle comes into contact with the underside of the vehicle. Now raise the car until the chassis stands can be placed beneath the car. [. . . ] Se till att inga personer, speciellt barn uppehåller sig i närheten av fordonet och att personer som arbetar med fordonet har tillräckligt säkerhetsavstånd till fordonet när domkraften används. P j rid den i pilens riktning V (se bild A) till fordonet sänks, inte så långt att hydraulolja läcker ur sänkningsventilen 5 . [. . . ]