User manual WHIRLPOOL 8300649

[. . . ] If countertop thickness is more than 1-1/2" inches thick: Countertop must be notched as shown to avoid damaging the oven control panel. notch width to be equal both sides 1-1/2" max 30-1/8" 30-1/8" If countertop extends more 1-1/8" beyond cabinet front: Notch countertop as shown to clear oven control panel. cabinet front notch width to be equal both sides 1-1/8" max 13" max. countertop thickness Top view of cabinet cutout Proper installation is your responsibility. Range location should be away from strong draft areas, such as windows, doors and strong heating vents. [. . . ] Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or non-metallic sheathed, copper cable (with ground wire). Flexible armored cable from appliance should be connected directly to junction box. Wire sizes and connections must conform with the rating of the appliance and to the requirements of the National Electrical Code, ANSI/NFPA 70 -- latest edition (** See Page 1) and all local codes and ordinances. a. ) Connect the aluminum wiring to the copper wire using special connectors designed and Underwriters Laboratories-listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. b. ) Aluminum/copper connection must conform with local codes and industry-accepted wiring practice. Installation steps D Check cooktop operation. D Check oven operation. C C B Connect power supply cable. Grasp oven frame to lift range. Use screws to attach range to cabinet. Remove side trim. C A Remove oven racks. A A C Remove shipping feet. Remove trim screws. C Replace oven door. A Remove oven door. A Preparation WARNING Excessive Weight Hazard Use two or more people to move and install range. Do Not use handle or any portion of the front frame or trim for lifting. Before moving range across floor, check that range is on shipping base or slide range onto cardboard or hardboard. Do Not remove shipping feet at the front lower corners of range. latch on the hinge in locked position ­ door free to open and close latch on the hinge in unlocked position ­ door ready for removal Remove trim screw. Pull trim out. Pull top of trim down. 1. Turn power supply off. · Remove and discard shipping materials, tape and protective film from the range. remove shipping base or shipping feet at the front lower corners of range. The shipping feet will protect the lower range trim until range is inserted into cabinet. · Remove and set aside oven racks and other parts from inside oven. etely open oven door. [. . . ] Replace trim screw. Lift range into cabinet cutout using the oven opening as an area to grip. " If your oven does not heat or an "F" followed by a , number, appears in the display, contact your dealer or check the "If you need service. . . section " of this Installation Instructions. Page 3 If range does not operate: Check that circuit breaker is not tripped or house fuse blown. [. . . ]