User manual WHIRLPOOL 881406658997

[. . . ] · Always leave hot food to cool before placing in the appliance. Climatic Class SN N ST T Amb. (°C) From 10 to 32 From 16 to 32 From 16 to 38 From 16 to 43 Amb. (°F) From 50 to 90 From 61 to 90 From 61 to 100 From 61 to 110 INSTALLATION Switching on the appliance · Please refer to the chapter "BEFORE USING THE · The appliance is factory set for optimum operation at a temperature of -18°C. · Plug in the appliance. · Also the red LED (if provided) will switch on because the contact with the walls of appliance: A) - foods to be frozen, B) - foods already frozen. [. . . ] · Remove the 4 protection pieces inserted between lid and appliance. · Warning: two of the four protection pieces must be fitted in the seat of the condenser plastic supports, located at the rear of the product. This is necessary to ensure the correct distance from the wall. appliance. · Avoid, or reduce temperature variations to the minimum. Respect the best-before date on the package. · Always observe the storage information on the package. · Ensure that the defrosting water drainage plug (if provided) is correctly positioned (5). Note: Eat fully or partially defrosted foods immediately. If there is a long power failure: · Do not open the appliance lid except to place ice packs (if provided) over the frozen foods on the right and left of the appliance. This will slow down the rise in temperature. · For best operation of the appliance and in order to avoid damage when the lid is opened, leave a space of at least 7 cm from the rear wall and 7 cm at the sides. · Fit the accessories (if provided). temperature inside the appliance is not yet sufficiently low for food storage. The red LED will normally switch off within the first six hours after the appliance is switched on. · After connecting the appliance to the mains supply and when the optimal temperature has been reached (this phase takes about 1 hour during which the lid will not open), ensure that the fast freeze button is not pressed (the yellow LED, if provided, is off) · Place food inside the product only when the red LED (if provided) has switched off. · Thanks to the efficient lid seal, the appliance lid will not re-open easily immediately after closing. Temperature Adjustment Use the thermostat to select the ideal storage temperature. To adjust the internal temperature, proceed as follows: · Turn the thermostat knobto 1 for a storage temperature that is less cold. · After installation, make sure that the appliance is not · Is there a power failure?· · Do not store glass containers with liquids in the appliance · Is the electric cable intact?The green LED (if provided) is off and the appliance is · Do not eat ice cubes or ice lollies immediately after taking working. · · Before servicing or cleaning the appliance, unplug it from · The green LED is not working. Contact the After Sales the mains or disconnect the electrical power supply. sunlight or near heat sources in order to avoid increasing · Have hot foods been put in the appliance?· · Do not store or use petrol or other flammable vapours and · Has the appliance lid been left open for a long time?· Is the appliance positioned in a very warm room or near · The fumes can create a fire hazard or explosion. · · Install the appliance in a perfectly horizontal position, on a floor · Is the thermostat setting correct?strong enough to take its weight and in an area suitable for its CARE AND MAINTENANCE · Has the fast freeze function (depending on model) been · Remove the ice from the upper edge (see the size and use. The appliance is set for operation at specific ambient · Clean the inside after defrosting, using a sponge dampened 6. [. . . ] "Installation") · If the appliance is left empty for short periods, it is Before carrying out maintenance, unplug the appliance. Do not use abrasive products, scourers or · Be careful not to damage the floors when you move the "Installation") stain-removers (e. g. · Do not use mechanical devices or any means other than appliance those recommended by the manufacturer to speed up the To obtain the best results from your appliance, carry · It is normal for condensation to form under certain out cleaning and maintenance at least once a year. atmospheric conditions (humidity above 85%) or if the · Do not use electrical appliances inside the product, unless CHANGING THE LID such appliances are specifically recommended by the appliance is located in a damp or poorly ventilated room. [. . . ]