User manual WHIRLPOOL ADG 993/3 IX INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL ADG 993/3 IX. We hope that this WHIRLPOOL ADG 993/3 IX user guide will be useful to you.


WHIRLPOOL ADG 993/3 IX INSTRUCTION FOR USE: Download the complete user guide (196 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL ADG 993/3 IX KURZANLEITUNG (125 ko)
   WHIRLPOOL ADG 993/3 IX MODE D'EMPLOI (172 ko)
   WHIRLPOOL ADG 993/3 IX SCHEDA PROGRAMMI (125 ko)
   WHIRLPOOL ADG 993/3 IX GEBRUIKSAANWIJZING (165 ko)
   WHIRLPOOL ADG 993/3 IX BEDIENUNGSANLEITUNG (167 ko)
   WHIRLPOOL ADG 993/3 IX TABLEAU DE PROGRAMMES (126 ko)
   WHIRLPOOL ADG 993/3 IX INSTRUZIONI PER L'USO (167 ko)
   WHIRLPOOL ADG 993/3 IX LIBRO DE INSTRUCCIONES (167 ko)
   WHIRLPOOL ADG 993/3 IX PROGRAM CHART (123 ko)
   WHIRLPOOL ADG 993/3 IX SCHEDA PROGRAMMI (125 ko)

Manual abstract: user guide WHIRLPOOL ADG 993/3 IXINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it since the appliance may topple over. [. . . ] If instead crockery is wet, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). Electric indicator: The indicator lamp on the control panel illuminates when the rinse aid dispenser is empty. Visual indicator: light= empty; dark= full. 15 HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. The use of detergent in excess of the recommended dosage may cause pollution. For programmes with additional selected functions: “Half load”: load the upper or lower rack only. Use a smaller quantity of detergent. Normal load: For programmes with pre-rinse. (Example: Normal 65°C refer to the “Wash programme chart”). For programmes without pre-rinse: • Pour the entire recommended dosage in the large compartment. If the recommended dosage on the detergent pack is over 45 ml, pour the remaining detergent in the small compartment. 16 HOW TO USE THE DISHWASHER Close the dishwasher door and turn on the water tap. 1. Once set, the programmed data cannot be altered by turning the programme selector knob or pressing the buttons. Note: Once the Start button has been pressed, the dishwasher memorises all the programmes selected. The selected programmes are also saved in the event of power failure. 2 3. To change the programme selected, press the Start button for about 5 seconds until the Start indicator lamp switches off. Select a new programme using the programme selector knob and press the Start button. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. t 3 4. Turn the programme selector knob counter clockwise to the “0” position to switch off the dishwasher (only after the End indicator lamp has illuminated briefly or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 4 17 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. [. . . ] The appliance will not switch on: • Power plug properly inserted in the mains socket?To do this, turn off the water tap, disconnect the water hose, clean the filter, reconnect the water hose to the tap and turn on the tap. When loading large items in particular, make sure the water circulates and does not collect inside them. The Start indicator lamp flashes: Other fault signals on the model installed: End depending The programme progress indicator lamp on the control panel flashes: Detach the lower spray arm. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL ADG 993/3 IX




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL ADG 993/3 IX will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.