User manual WHIRLPOOL AKM280/WH/01 INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AKM280/WH/01. We hope that this WHIRLPOOL AKM280/WH/01 user guide will be useful to you.


WHIRLPOOL AKM280/WH/01 INSTRUCTION FOR USE: Download the complete user guide (215 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AKM280/WH/01 KURZANLEITUNG (280 ko)
   WHIRLPOOL AKM280/WH/01 MODE D'EMPLOI (266 ko)
   WHIRLPOOL AKM280/WH/01 GEBRUIKSAANWIJZING (234 ko)
   WHIRLPOOL AKM280/WH/01 BEDIENUNGSANLEITUNG (294 ko)
   WHIRLPOOL AKM280/WH/01 TABLEAU DE PROGRAMMES (51 ko)
   WHIRLPOOL AKM280/WH/01 INSTRUZIONI PER L'USO (262 ko)
   WHIRLPOOL AKM280/WH/01 LIBRO DE INSTRUCCIONES (238 ko)
   WHIRLPOOL AKM280/WH/01 PROGRAM CHART (51 ko)

Manual abstract: user guide WHIRLPOOL AKM280/WH/01INSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] When scrapping it, follow the local environment protection disposal regulations. Before disposing of it, cut its power cable off in order to render it inoperative. PRECAUTIONS AND GENERAL SUGGESTIONS x x x x x Before any cleaning or maintenance operation, disconnect the cooking hob from mains power supply. Make sure that the room is well ventilated, or install an extractor hood with exhaust duct. In case of prolonged use, additional ventilation may be needed (open a window or increase the extraction force of the hood). [. . . ] The burner fails to remain lit: y Repeat the ignition operation, turning the knob to the position with the small flame symbol . The electric ignition device does not work: y Is there a power failure? AFTER-SALES SERVICE Before you call the After-Sales Service: 1. Carefully check the “Troubleshooting guide” above to see if you can fix the problem yourself. Re-start the cooking hob, to check whether correct operation has been restored. Give the following information: x type of malfunction; x model of cooking hob; x service number (i. e. , the number that follows the word SERVICE on the rating plate under the cooking hob and on the guarantee paper); x your complete address; x your telephone number and area code. If any repairs are required, please contact an authorised customer service centre, as indicated in the warranty. In the unlikely event that an operation or repair is carried out by an unauthorised technician, always request a certification of the job carried out and insist on the use of original spare parts. Failure to comply with these instructions may compromise the safety and quality of the product. l 55 M 55 GB 68462/D Y N C INSTALLATION Technical information for the installer This cooking hob can be embedded in a worktop 20 to 50 mm thick. If another appliance is not fitted under the cooking hob, insert a separator panel, at a distance of at least 20 mm from the cooking hob bottom. Note: before installation, make sure that the local gas delivery conditions (type and pressure of gas) are compatible with the settings of the cooking hob, as indicated on the rating plate. x If a vertical piece of furniture is installed, there must be a gap of at least 100 mm between it and the edge of the cooking hob. x Before installing the cooking hob, remove the plastic film that protects it, if present. The outer surfaces of the furniture or appliances adjoining the cooking hob must be heat resistant (heat protection “Y”, according to local standards). x x x Installation must comply with current local regulations. In the room where the cooking hob is installed, there must be enough air to allow the gas to burn correctly (see relevant table). The natural flow of air must take place through an adequate opening, that must be: - permanent, made on one of the outside walls of the room, and communicating with the exterior in an area away from sources of pollution; - built so as to ensure that its openings, both on the inside and on the outside, cannot be obstructed, intentionally or accidentally; - protected by a metal grid or mesh that does not reduce its working section; - situated near the floor level and positioned so as not to interfere with the operation of the fume exhaust devices. Assembly x Apply the supplied gasket to the cooking hob (unless it has already been fitted), after having cleaned its surface, as shown in figure. To fix the cooking hob, use brackets supplied with it. Position the brackets on the relevant bores and fix them by means of their screws. Make an opening in the worktop, respecting the dimensions indicated in the enclosed product description sheet. Important: the power supply cable and plug must be suitable for the power absorption of the cooking hob, and the cable must be long enough to permit the upward extraction of the cooking hob. a 56 M 56 GB 68461 Y N C INSTALLATION Electrical and mechanical connection x x x The electrical connections must comply with local regulations. The data relevant to the voltage and power absorption are indicated on the rating plate. The earthing of this appliance is compulsory by law. x The manufacturer cannot be held responsible for any injury to persons or animals or damage to property arising from failure to comply with these requirements. [. . . ] Connect the cooking hob to the gas shut-off valve by means of a pipe suitable for the type of gas used, in compliance with current local regulations. Note: when liquid petroleum gas G 30/G 31 is used, the minimum gas setting screws must be tightened as far as they will go. Replacing the injectors (see table in enclosed product description sheet) 1. Using a socket spanner of the appropriate size unscrew the injector to be replaced. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AKM280/WH/01




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AKM280/WH/01 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.