User manual WHIRLPOOL ARF 210/A PRODUCT FICHE

[. . . ] Indicates a hazardous situation which, if not avoided, could cause serious injury. All safety warnings give specific details of the potential risk present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions: -- The appliance must be disconnected from the power supply before carrying out any installation work. -- Electrical installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. [. . . ] Once the set time has elapsed: An acoustic signal sounds and flashes on the display . With knob B set to “0”, press buttons “+” and “-” at the same time for 3 sec. The oven functions will not operate while the childproof lock is activated. Preheat the oven to the required temperature and place the food in it when the set temperature is reached. This function is also suitable for cooking frozen convenience foods; Follow the instructions on the food packaging. For baking cakes with liquid filling (sweet or savoury), pizzas on a single or double level. When cooking on two levels, switch the position of the dishes halfway through cooking to cook food more evenly. Preheat the oven to the required temperature and place the food in it when the set temperature is reached. to grill steak , kebabs and sausages , to cook vegetables au gratin and to toast bread. 0 OVEN OFF LAMP CONVENTIONAL 225°C CONVECTION BAKE 200°C 50 - 250°C GRILL 3 1-3 ENGLISH 12 Function TURBO GRILL Preset temperature / Power level 3 Temperature range / Grill range 1-3 Description of function To roast large joints of meat (legs, roast beef, chickens). Leave food in its packaging in order to prevent it from drying out on the outside. NOTE: during the pyrolysis function, the oven door will not open; it will remain locked until the temperature inside the oven has returned to an acceptably safe level. -- Ensure the oven is cold before carrying out the following operations. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. 8), replace the lamp (see note for lamp type) and screw the lamp cover back on. IMPORTANT: using halogen lamps, do not handle with bare hands since fingerprints can damage them. Problem The oven does not work: Possible cause No electrical power supply. The selector knob is set to “ The oven door is locked and will not release (Nutid OV9 – Framtid OV9 version) The oven door is locked and will not release (Framtid OV5 – Datid OV7 version) Electrical malfunction due to voltage fluctuations. Solution Verify the presence of mains electrical power Connect the oven to the power supply. Switch the oven off and then on again to see if the fault has been eliminated. -- Set the clock to (see “Control panel”) Wait 2 minutes for the door to be released. The electronic programmer does not work (Nutid and Framtid OV9 version) Electrical malfunction due to voltage fluctuations. [. . . ] If considered covered, IKEA Service Provider or its authorized service partner through its own service operations, will then, at its sole discretion, either repair the defective product or replace it with the same or a comparable product. € Deliberate or negligent damage, damage caused by failure to observe operating instructions, incorrect installation or by connection to the wrong voltage, damage caused by chemical or electrochemical reaction, rust, corrosion or water damage including but not limited to damage caused by excessive lime in the water supply, damage caused by abnormal environmental conditions. € Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible color differences. • Accidental damage caused by foreign objects or substances and cleaning or unblocking of filters , drainage systems or soap drawers. [. . . ]