User manual WHIRLPOOL AWE 7727 PRODUCT FICHE

[. . . ] Please avoid excessive detergent dosing.  = optional / Yes = dosing required Whirlpool is a registered trademark of Whirlpool USA. 5019 312 10688 CONSUMPTION DATA Programme Cotton Cotton ** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Lingerie Temperature (°C) 95 60 40 60 40 40 40 30 40 40 30 Load (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 50* 49 55 50* 45 50 40 35 55 40 40 Energy (kWh) 1. 70 0. 95 0. 55 0. 80 0. 45 0. 55 0. 45 0. 40 0. 55 0. 40 0. 30 Approx. Programme Duration (hours : minutes) 2:05 2:10 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:35 0:35 Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. “Eco” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption is achieved. • Selectable for programmes Cotton 95ºC and Synthetics 60ºC. “Intensive rinse” button • The amount of water is increased to ensure a more intensive rinse. To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 second. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. [. . . ] “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. [. . . ]