User manual WHIRLPOOL AWM 8105/1 PROGRAM CHART

[. . . ] With heavily soiled laundry the additional “Prewash” option can be selected as well. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. [. . . ] • If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. • Reselect the desired programme and options and press the “Start/Pause” button. PROGRAMME START Open the tap and press the “Start/Pause” button. The pilot lamp of the “Start/Pause” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamp goes out. DOOR LOCK The door can be opened when the “Door Open” indication is on. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. The spin indicators show “0” and the remaining time shows “0:02”. Press the “Start/Pause” button to start the drain programme. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programme “Synthetics” or “Delicates”. [. . . ]