User manual WHIRLPOOL AWO/C 6340 INSTRUCTION FOR USE

[. . . ] Briefly worn clothing made of cotton, artificial fibres and blends with cotton. Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] To remove it again, keep on pressing the button until you see the value “0:00”. • When you have selected the desired time until the “Cycle end”, press “Start/Pause” - the countdown will begin. • During the countdown, you can still modify the programme setting (select or deselect options, change spin speed etc. ). If the modifications prolong the programme duration so that it overruns the originally set time until the “Cycle end”, the programme will start immediately. • Sometimes the programme may finish before the selected time until the “Cycle end” has expired (e. g. In this case, the washing machine will tumble the laundry regularly to keep it fresh, until the selected “Cycle end” time has expired. The tumbling phase can be stopped at any time either by pressing any button or by rotating the programme selector; the animation will stop and the door will unlock in about 1 minute as indicated on the display. FAILURE INDICATION In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed”: no or not sufficient inlet water ”Service”: failure or malfunction of an electrical component ”Clean pump”: waste water is not pumped out. Spin speed on display blinks: unbalance during spinning. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. [. . . ] • Make sure that your detergent is suitable for cold wash temperatures (15 or 20°C). “Intensive rinse” button • More water is added and rinse cycle is prolonged. [. . . ]