User manual WHIRLPOOL AWO/D 060 PRODUCT FICHE

[. . . ] To avoid noise of spinning at night, set spin speed to “0” and start spin programme in the morning, or define programme start with “Start Delay” accordingly. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly to normally soiled textiles made of cotton and/or synthetics. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. [. . . ] Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. Alternative method of terminating programme after “Rinse hold”. E. “Start delay” button G E F Programme Cotton Cotton 40 °C Care Labels Detergents and Additives PreMain Softener Start wash Wash delay Départ différé  Eco Eco Special options Pre- Intensive Rinse hold wash rinse Pré- Rinçage Arrêt cuve lavage plus pleine    Variable spin Essorage variable  Max. Spin Speed rpm 60 - 95 °C 60 - 95 °C Coton Coton 40 °C Yes    Max. SuperEco 20 - 60 °C Super 20 - 60 °C 6. 0  Yes   – –    Max. 30 - 40 - 60 °C Synthetics Delicates 30 - 40 °C Synthétiques 30 - 40 - 60 °C 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 – – –  Yes Yes Yes Yes Yes Yes – – –        1000 1) 1000 1) Max. Max. – Delicates 30 - 40 °C  – – – – – – –   – – – – – – – –  – – – – – – – –   Daily load 40 °C 40 °C    – – –  – –   Quick wash 30 °C Chrono 30 °C     Cold - 40 °C Wool Froid - 40 °C Laine     Handwash 30 - 40 °C Lavage main 30 - 40 °C   – –       – –    – Rinse & Spin Spin Drain Rinçage & Essorage Essorage Vidange 6. 0 6. 0 –  : option / Yes : dosing required 1) For improved garment care, spin speed is restricted in these programmes. Whirlpool is a registered trademark of Whirlpool USA. 5019 301 01064 CONSUMPTION DATA Programme Cotton/ Antibacterial Cotton Cotton with “Eco”** Cotton SuperEco Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Handwash Temperature (°C) 95 60 60 40 60 60 40 30 40 30 40 40 30 Load (kg) 6. 0 6. 0 6. 0 5. 0 6. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 59* 49 49 56 51 50* 46 60 41 41 60 45 45 Energy (kWh) 1. 90 1. 14 1. 02 0. 70 0. 72 0. 80 0. 50 0. 50 0. 50 0. 40 0. 50 0. 50 0. 40 Approx. Programme Duration (hours : minutes) 2:00 2:10 2:20 2:00 4:00 1:35 1:20 0:41 1:00 0:30 0:46 0:41 0:37 “Variable spin” button • Every programme has a predefined spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only. START DELAY RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. The indication neto to the “Start delay” button lights up and goes off when the programme starts. • Once having pressed the “Start/Pause” button, the countdown of the time delay begins. When the programme starts, the start delay indicator lights goes off and is replaced by the programme sequence indications. • After the “Start/Pause button has been pressed, the number of hours preselected can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 second - the start delay indicator light goes out. PROGRAMME START • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. “Eco” button • With modified temperature profile and a slightly prologned washing duration, the optimum combination of excellent washingresult and even lower energy consumption is achieved. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. [. . . ] • Do not use liquid detergent for the main wash when activating the Prewash option. Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. “DOOR OPEN” INDICATION 1. [. . . ]