User manual WHIRLPOOL HDD W00 S INSTRUCTION FOR USE

[. . . ] The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket. The electrical components must not be accessible to the user after installation. Do not touch the appliance with any wet part of the body and do not operate it when barefoot. The appliance is not intended for use by persons (including children) with any physical, sensory or mental impairment, or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. [. . . ] Recirculation model (see symbol in installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. Important: If the hood is supplied without charcoal filters, these must be ordered and fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. However, ask a qualified technician to check that the items supplied are suitable for the type of wall/ceiling. 2 4 3 4 5 Control panel A Light switch: move right to switch the light on. B Suction power selection switch: move right to switch on and to select the desired power/speed 0 1 0 1 2 3 A B Cleaning and maintenance WARNING: - Never use steam cleaning equipment. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. iMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. € Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. To clean the grease filter The metal grease filter has an unlimited life and must be washed once a month by hand or dishwasher at low temperature and with a short cycle. With cleaning in a dishwasher ENGLISH 8 the grease filter may become dull; this does not effect its filtering capacity. Remove the grease filters: pull the spring release handle, then remove the filter downwards. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. Replacing the Halogen lamps WARNING: - Only use 20W MAX - G4 halogen lamps. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentlepressure remove the light cover from its position. If charcoal filters are already present (two filters fitted, covering the protection grids of the motor impeller) and must be replaced, turn the central handle anticlockwise to unlock them. Problem The appliance does not work Possible cause There is no mains electrical power Solution Check for the presence of mains electrical power. Check that the filters are clean If not, clean the filters in the dishwasher. The appliance is not connected to the electrical supply The hood’s suction level is not enough The suction speed is too low The metal filters are dirty The air vents are obstructed The light does not work The light bulb is broken The light bulb is not correctly fitted Before contacting the After-sales service: Switch the appliance on again to see if the problem has disappeared. [. . . ] In order to provide you a quicker service, we recommend to use the specific phone numbers listed on this manual. Always refer to the numbers listed in the booklet of the specific appliance you need an assistance for. Please also always refer to the IKEA article number (8 digit code) and 12 digit service number placed on the rating plate of your appliance. The sales receipt also reports the IKEA name and article number (8 digit code) for each of the appliances you have purchased. [. . . ]